Frigidaire FPWD3085K Food Warmer User Manual


  Open as PDF
of 3
 
Specifications
subject to change.
FRIGIDAIRE®
USA
•
250 Bobby Jones Expressway
•
Martinez, GA 30907
•
1-800-FRIGIDAIRE
•
frigidaire.com
CANADA
•
5855 Terry Fox Way
•
Mississauga, ON L5V 3E4
•
1-800-265-8352
•
frigidaire.ca
MOSS_EW_WD 30INST FR 04/09 © 2009 Electrolux Home Products, Inc. Printed in the U.S.A.
30" Electric Single Wall Oven Specifications
•
Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz
AC only electrical supply with ground required on separate circuit
fused on both sides of line.
•
For detailed electrical requirements, refer to model-specific product
page and installation guide on web.
•
To support Wall Oven when using in combination with Warmer
Drawer, two 3"-wide x 3/4"-thick planks must be installed as a base,
capable of supporting 200 Lbs. Do NOT use full base, since planks
are necessary to allow for proper air displacement.
30" Warmer Drawer Specifications
•VoltageRating–120V / 450W / 60Hz / 15Amps
•ConnectedLoad(kWRating)@120Volts=0.5kW
(Foruseonadequatelywired120V,dedicatedcircuithaving2-wire
service with a separate ground wire. Appliance must be grounded
forsafeoperation.)
•Amps@120V=3.8Amps
•Fullbaseofsolidplywoodorsimilarmaterialrequired,capableof
supporting 100 Lbs.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
30" Combination Installation Specifications
•
Always consult local and national electric codes.
(Refer to product-specific electrical specifications on this page.)
•
Minimum23-5/8"deepcutoutdimensioniscriticalforproper
combination installation, to ensure that each built-in product’s
faceplate will fit flush against cabinet front.
•
Bases must be level and cabinet front must be square.
•
Minimum 4-1/2" required distance from bottom of Warmer Drawer
cutout to floor.
•
Respectcriticaldimensionsasnotedforproperinstallationof
built-In products.
•
Minimum 21" clearance needed for Wall Oven door depth when open.
30" Built-In Microwave Specifications
•
For built-in installation, microwave MUST be installed with optional
30"TrimKitwhichincludesBottomDuctAssembly–shippedin
separate box, ordered by individual part number.
•
VoltageRating–120V / 60Hz / 15or20Amps
•
ConnectedLoad(kWRating)@120Volts=1.7kW
(Foruseonadequatelywired120V,dedicatedcircuithaving2-wire
service with a separate ground wire. Appliance must be grounded
forsafeoperation.)
•
Amps@120Volts=14.3Amps
•
Full base of solid plywood or similar material required, capable of
supporting 100 Lbs.
•
Minimum2-7/8"clearancerequiredfrombottomofBuilt-InMicrowave
cutout to top edge of Wall Oven’s faceplate, leaving a 2" visible gap
between both product faceplates.
Frigidaire 30" Combination Installation –
24" Built-In Microwave (with 30" Trim Kit)
Electric Single Wall Oven
Warmer Drawer
30" Combination Installation
Built-In Microwave / Single Wall Oven / Warmer Drawer
 previous