Filter
Top Products
3
Electrical Information
These guidelines must be followed to ensure that safety
mechanisms in the design of this appliance will operate
properly.
• Refer to the serial plate for correct electrical rating. The
power cord of the appliance is equipped with a three-prong
grounding plug for protection against shock hazards. It must
be plugged directly into its own properly grounded three-prong
receptacle, protected with a 15 amp time delay fuse or circuit
breaker. The receptacle must be installed in accordance with
the local codes and ordinances. Consult a qualified electrician.
Receptacles with Ground Fault Circuit Interrupters (GFCI) are
NOT RECOMMENDED. DO NOT USE AN EXTENSION
CORD OR AN ADAPTER PLUG.
• If the voltage varies by 10 percent or more, appliance
performance may be affected. Operating the appliance with
insufficient power can damage the motor. Such damage is
not covered under the warranty. If you suspect your voltage is
high or low, consult your power company for testing.
• To prevent the appliance from being turned off accidentally,
do not plug the unit into an outlet controlled by a wall switch
or pull cord.
• DO NOT pinch, knot, or bend the power cord in any manner.
Other Precautions
• NEVER unplug the appliance by pulling on the power cord.
Always grip the plug firmly and pull straight out from the
receptacle.
• To avoid electrical shock, unplug the appliance before
cleaning.
NOTE: Turning the control to “OFF” turns off the compressor
but does not disconnect power to other electrical components.
Installation and Setup
Inspection for Damage
Inspect the underside of the cabinet and packaging for damage
such as a fork truck can cause. If hidden damage is found after
uncrating, immediately call the delivery carrier and request an
inspection. Retain all packaging and crating materials until the
inspection is complete.
Uncrating and Set-up
• Remove carton and all loose parts from inside of the unit.
• Tip the unit onto its back with the help of one assistant. Lay
the unit gently to rest on blocks to avoid damaging the
condensate drain hose, and the plastic raceway that covers
the evaporator tubing on the back of the cabinet.
• Remove and discard the two (2) wood skids from the bottom
and the four (4) screws (see the Fig. 1).
• Remove the bottom door hinge and screw on the lower left
hand side of the cabinet used to support the glass door
during shipping using a 3/8 socket wrench (see Fig. 2).
• Remove the package containing the casters from the unit. This
package will contain the following items:
• Two (2) caster rail supports (A)
• Two (2) spacer plates (B)
• Eight (8) carriage bolts (C)
• Four (4) bolts (D)
• Four (4) washers (E)
• Eight (8) locking nuts (F)
• Two (2) swivel casters (G)
• Two (2) fixed casters with brakes (H)
Avoid fire hazard or
electric shock. Do not use an extension cord
or an adapter plug. Do not remove any
prong from the power cord.
Figure 1
Figure 2