Filter
Top Products
10
AUTOMATIC ICE AND WATER DISPENSER
AUTOMATIC ICE & WATER DISPENSER OPERATING INSTRUCTIONS
Features may vary according to model.
5
43
2
1
6
dehsurC
ehtsserP dehsurC tsniagassalgsserP.daPhcuoTehtevobaraeppalliwrotacidniderA.ecidehsurctegotdaPhcuoT
.ecillahctacotelbissopsapurafsaelddapgnisnepsidECI
debuC
ehtsserP debuC ECItsniagassalgsserP.daPhcuoTeh
tevobaraeppalliwrotacidniderA.ecidebuctegotdaPhcuoT
.ecillahctacotelbissopsapurafsaelddapgnisnepsid
nOt
hgiL
ehtsserP nOthgiL .daPhcuoTehtevobaraeppalliwrotacidniderA.thgilresnepsidnonrutotdaPhcuoT
ffOthgiL
eht
sserP ffOthgiL .daPhcuoTehtevobaraeppalliwrotacidniderA.thgilresnepsidffonrutotdaPhcuoT
RETAWresnepsidret
awehtetarepooT llup,retawgnisnepsidpotsoT.elddapgnisnepsidRETAWehttsniagassalgasserp,
sebucroecidehsurc
dda,retawredlocroF.dloctonsiretawdesnepsiD.elddapgnisnepsidehtmorfyawassalgeht
.etaropaveotmehtswollad
nasllipsllamssehctacresnepsidehtfoesabehttadetacolyartpirdA.retawgnisnepsiderofeb
efasrehsawhsiddnaelb
avomersiyartpirdsihT aerasihtniecissecxednaretawruoptonoD. .niardonsierehtesuaceb
1
5
2
5
3
4
6
6
HOW THE WATER DISPENSER WORKS
The water tank, located behind the drawers in the refrigerator
compartment, automatically fills as water is dispensed. For
proper dispenser operation, the recommended supply water
pressure should fall between 30 psi and 100 psi.
After the refrigerator is connected to the water supply, fill the
water tank by drawing one glass of water. It may take about
1½ minutes after activating the dispenser paddle before water
begins to fill this first glass. Continue flushing the system for 3
minutes to rid the tank and plumbing connections of any
impurities. The water dispenser has a built in shutoff device
that will stop the water flow after 3 minutes of continuous use.
Simply release the dispenser paddle to reset the shutoff
mechanism.
HOW THE ICE DISPENSER WORKS
The ice maker and container are located in the top of the
freezer compartment. After the refrigerator is installed properly
and has cooled for several hours, the ice maker can begin
making ice within 24 hours. Air in new plumbing lines may
cause the ice maker to cycle two or three times before making
a full tray of ice. To begin ice production, lower the wire signal
arm to the "down" or ON position. With no usage it will take
approximately 2 days to fill the ice container. The ice maker
turns off automatically when the ice container becomes full. To
stop the ice maker, lift the wire signal arm until it clicks, and
locks in the "up" or OFF position.
Because of new plumbing
connections, the first
production of ice cubes may
be discolored or have an
odd flavor. These should be
discarded until the cubes
made are free of
discoloration and taste.
CAUTION CAUTION
CAUTION CAUTION
CAUTION
Water pressure must not exceed 100 lbs. Excessive
pressure may cause water filter to malfunction.
Chemicals from a malfunctioning softener can damage
the ice maker. If the ice maker is connected to soft
water, ensure that the softener is maintained and
working properly.
ON
OFF
Wire
Signal Arm