15
The
TM
ice and water
ltersystemistestedandcertiedbyNSF
International, the nationally respected,
not-for-protcerticationorganizationfor
public health safety. The
TM
iceandwaterltersystemistestedand
certiedtoANSI/NSFStandards42and53forthe
reductionofclaimsspeciedontheperformancedata
sheet.
Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection
beforeorafterthesystem.Systemscertiedforcyst
reduction may be used on disinfected waters that may
containlterablecysts.
• RatedCapacity-200gallons/757litersfor
TM
iceandwaterlter
• Ratedserviceow-.50gallonsperminute
• OperatingTemp.:Min.33°F,Max.100°F
• MaximumRatedPressure-100poundsper
square inch
• RecommendedMinimumOperatingPressure:30
pounds per square inch
7 Afterllingoneglassofwater,continueushing
the system for about .
8 Turn the ice maker.
9 Press and hold the button on the Ice
& Water Dispenser control panel for three seconds.
When the display changes from “” to
“,” the status has been reset.
TM
It is not necessary to turn the water supply off to change
thelter.Bereadytowipeupanysmallamountsof
waterreleasedduringthelterreplacement.
Turn the ice maker power switch.
2 Removethelterbypushingontheend/faceof
thelter.
3 Slidetheoldwaterltercartridgestraightoutof
the housing and discard it.
4 Unpackagethenewltercartridge.Usingthe
alignmentguide,slideitgentlyintothelter
housing until it stops against the snap-in connector
at the back of the housing.
Press a drinking glass against the water dispenser
whilecheckingforanyleaksatthelterhousing.
Any spurts and sputters that occur as the system
purges air out of the dispenser system are normal.