Filter
Top Products
9
TEMPERATURE CONTROLS
SYSTEM-MONITORING ALARMS
The electronic control system continuously monitors your
refrigerator/freezer for temperature consistency and doors left
ajar. Variances from normal operating conditions are
communicated by audible tones and a set of two status
indicator lights.
RESPONDING TO ALARMS (AUDIBLE TONES &
INDICATOR LIGHTS)
Your refrigerator’s control system can convey the following
information through audible tones and the alarm indicator
lights.
Door
Ajar
Flashing
Green
Freezer or Fresh Food
door has been open for
over five minutes.
Close door to silence and reset alarm.
AIR FILTER INDICATOR & STATUS LIGHTS
Your refrigerator’s fresh food air filter needs to be replaced from time to time. You can monitor the need for replacement by
referring to the status light while the air filter is “ON”. To turn on the air filter, press the “Air Filter” button. To turn off the air filter,
press the “Air Filter” button. To RESET the air filter, press the “Air Filter” button and hold for 3 seconds.
Air Filter Status Light (not available on all models)
Green Filter OK.
Yellow Air filter is about 80 percent used. Please order new one.
Red Air filter is 100 percent used. Please change now.
TURNING THE COOLING SYSTEM ON AND OFF
You can disable the cooling system in your refrigerator by
pressing the On/Off button located on the left side of the
temperature control panel.
To ensure that you do not accidentally turn off the cooling
system, the button does not work unless you press
and hold
it
for three seconds.
While the cooling system is “OFF”, the digital display will show
“OF” “OF” for temperature display models and “O” “F” for
numeric display models.
Once you disable the cooling system, all refrigeration to the
freezer and fresh food compartments stops.
To turn the cooling system back on, you must again press
and
hold
the On/Off button for three more seconds.
Cooling System On/Off Button
IMPORIMPOR
IMPORIMPOR
IMPOR
TT
TT
T
ANTANT
ANTANT
ANT
The On/Off button only controls your refrigerator’s cooling
system. Power to lights and other electrical components
continue unless you unplug the power cord.