Filter
Top Products
8
SETTING OVEN CONTROLS
ENERGY SAVING
The TIMER pad control the Continuous Bake or 12 Hour
Energy Saving features. The oven control has a factory
preset built-in 12 Hour Energy Saving feature that will shut
off the oven if the oven control is left on for more than 12
hours. The oven can be programmed to override this feature
for Continuous Baking.
To set the control for Continuous Bake or 12 Hour
1. Press and hold TIMER for 7 seconds.
After 7 seconds “” or “12hr” will appear in the
display and the control will beep once.
2. Press the UP or DOWN ARROW pad to switch
between the 12 Hour Energy Saving and continuous
bake features.
Note: “12hr” in the display indicates the control is set for the
12 Hour Energy Saving mode and indicates the
control is set for the Continuous Bake feature.
3. Wait 5 seconds to accept the changes or press CANCEL
pad to reject the changes.
FAHRENHEIT OR CELSIUS:
The BROIL and ARROW pads control the Fahrenheit or
Celsius temperature display modes. The oven control can
be programmed to display temperatures in Fahrenheit or
Celsius. The oven has been preset at the factory to display
in Fahrenheit.
To change display from Fahrenheit to Celsius or
Celsius to Fahrenheit
1. Press and hold BROIL pad for 7 seconds until °F or °C
appears in the display.
2. Press the UP or DOWN ARROW pad to change °F to
°C or °C to °F.
3. Wait 5 seconds to accept the changes or press CANCEL
pad to reject the changes.
The pad is used to set the clock. The clock may
be set for 12 or 24 hour time of day operation. The clock
has been preset at the factory for the 12 hour operation.
When the range is rst plugged in, or when the power
supply to the range has been interrupted, the timer in the
display will ash “12:00”.
To set the clock (example below for 1:30)
1. Press .
2. Within 5 seconds, push and hold the UP or DOWN
ARROW pad until the correct time of day appears in
the display.
3. Press the pad to accept the new time of day.
If the pad is not pressed, the timer will return
automatically to the new time of day after 7 seconds.
Note: The clock cannot be changed during any bake,
quick bake, timed bake, delayed time bake, clean
cycle, quick clean or delayed clean cycle.
CHANGING BETWEEN 12 OR 24 HOUR TIME
OF DAY DISPLAY
1. Press and hold the SET pad for 7 seconds.
After 7 seconds, “12Hr” or “24Hr” will appear in the
display and the control will beep once.
2. Press the UP or DOWN ARROW pad to switch between
the 12 and 24 hour time of day display. The display will
show either “12Hr” or “24Hr”.
3. Wait 5 seconds or press the CANCEL pad to return to
the time of day display.
4. Reset the correct time as described in To set the Clock
above. Please note that if the 24 hour time of day mode
was chosen, the clock will now display time from 0:00
through 23:59 hours.
OVEN LIGHT
The oven is equipped with oven lights. The oven lights will
turn on automatically, when the oven door is opened.
The oven light may be turned on when the door is closed by
using the oven light pad located on the control panel. The
oven light key will toggle the lights at full intensity.
1. Press OVEN LIGHT .
The interior oven lights are covered with a glass shield held
by a wire holder. The glass shield must be in place whenever
the oven is in use.
To change the interior oven lights, see “Changing the oven
light” in the Care & Cleaning section.