Filter
Top Products
1313
1313
13
Making the electrical connections
Electrical Shock Hazard
Warning: Turn off power at the service panel before
wiring this unit.
120 V120 V
120 V120 V
120 V
AC, 15 or 20 Amp cirAC, 15 or 20 Amp cir
AC, 15 or 20 Amp cirAC, 15 or 20 Amp cir
AC, 15 or 20 Amp cir
cuit rcuit r
cuit rcuit r
cuit r
equirequir
equirequir
equir
ed.ed.
ed.ed.
ed.
ELECTRICAL GROUNDING INSTRUCTIONSELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONSELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW
WIRE MUST BE CONNECTED TO THE
GROUNDING WIRE IN YOUR
HOME ELECTRICAL SYSTEM, AND IT MUST
UNDER NO CIRCUMSTANCES BE CUT OR REMO-
VED.
FailurFailur
FailurFailur
Failur
e to do so can re to do so can r
e to do so can re to do so can r
e to do so can r
esult in death or electricalesult in death or electrical
esult in death or electricalesult in death or electrical
esult in death or electrical
shock.shock.
shock.shock.
shock.
• Remove junction box cover and knockout on the
top left side.
Knockout
Junction box
cover
• If not already done, install 1/2” conduit connector
in j-box.
Metal electrical
conduit
U.L. listed
wire nut
House
wiring
• Run black (live), white (neutral), and green (earth)
wires (#14 AWG) according to the National
Electrical Code or CSA Standards and local
codes and ordinances in 1/2” conduit from power
supply to j-box.
• Connect black, white, and green wires from
power supply to black, white, and green/yellow
wires in j-box respectively.
• These connections should be done always
making reference to the electrical diagram found
inside the hood.
• Close j-box cover and reapply screws.
Mounting the glass canopyMounting the glass canopy
Mounting the glass canopyMounting the glass canopy
Mounting the glass canopy
• With the hood mounted on the wall slide the glass
canopy over the glass supports.
• Insert the glass brackets.
• Insert two screws into the bracket holes, drive the
screws by hand.
Installing the hood