Filter
Top Products
5
Your model may be equipped with the clock and minute timer shown below.
To set the clock and minute timer, follow these instructions:
To Set the Clock
When the range is first plugged in, or when the power supply to the range has
been
interrupted, "12:00" will flash in the display window.
1. Press pad C (CLOCK).
2. Press and hold pad A (HOUR) until the correct hour appears in the display.
(The numbers will only count forward.)
3. Press and hold pad B (MINUTE) until the correct minutes appear in the
display.
To Set the Minute Timer
1. Press pad D, "0:59" (59 MINUTES) will appear in the display window. The
timer can be set for any amount of time from 1 minute to 1 hour and 59
minutes.
2. To set a time more than 59 minutes, press and release pad A (HOUR). The
timer will jump in at the maximum 1 hour and 59 minutes. The time can
now be adjusted down by pressing and holding pad B (MINUTE) until the
correct time appears in the display window.
To set a time less than 59 minutes, press and hold pad B (MINUTE) until
the correct minutes appear in the display. (The minute timer will
automatically start when the pad is released.)
3. When the set time has passed, the control will display "0:00" and beep
continuously. Press pad C (CLOCK) to cancel the timer and return to the clock
mode.
Setting the Clock and
Minute Timer
(some models)
Grounding Instructions
(electric ignition models only)
IMPORTANT: READ AND SAVE THESE INSTRUCTIONS.
This appliance is equipped with a 3-prong grounding plug for
your protection against shock hazard and should be plugged directly into a
properly grounded receptacle. DO NOT cut or remove the grounding prong
from this plug.
For personal safety, the range must be properly grounded. For maximum
safety, the power cord must be plugged into an electrical outlet that is correctly
polarized and properly grounded.
If a 2-prong wall receptacle is the only available outlet, it is the personal
responsibility of the consumer to have it replaced with a properly grounded 3-
prong wall receptacle installed by a qualified electrician.
DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE THIRD ROUND
GROUNDING PRONG FROM THE POWER CORD PLUG. SEE THE INSTALLATION
INSTRUCTIONS PACKAGED WITH THIS RANGE FOR COMPLETE INSTALLATION
AND GROUNDING INSTRUCTIONS. DO NOT OPERATE THE RANGE USING A 2-
PRONG ADAPTER OR AN EXTENSION CORD.
Avoid fire hazard or
electrical shock. Do not use an adapter
plug, an extension cord, or remove
grounding prong from electrical power
cord. Failure to follow this warning
can cause serious injury, fire or death.