Filter
Top Products
3-4
2. Press the Simmer switch again to lock in the setpoint. Press the ON/OFF switch to turn the
controller on and return to the normal operating mode.
3.1.5 Toggling Between Fahrenheit and Celsius Temperature Display
1. Press the Simmer switch. Code appears in the display, press 1, 6, 5, 8. The display will
toggle from Fahrenheit to Celsius, or from Celsius to Fahrenheit.
Press the Boil Mode switch to display the cookpot temperature. If an F follows the
temperature, the display is in Fahrenheit; if a C follows the temperature, the display is in Celsius.
SELECTING STANDARD OR SLOW CLOCK
The computer can be programmed for either “standard” or “slow” clock times. The standard clock
displays minutes and seconds, the slow clock displays hours and minutes.
To toggle back and forth between times press the Program Mode
switch, then enter the code
1 6 5 3 using the product buttons.
3.2 Boiling Out the Cookpot
The cookpot must be boiled out before first use.
1. Close the drain valve and fill the cookpot with a mixture of cold water and 1 cup of detergent.
2. Place the unit into operation.
3. Press the simmer switch, , and allow the solution to simmer for at least 1 hour.
4. After the solution simmers for 1 hour, turn the unit off and add cold water until the solution is
cool. Drain the solution and clean the frypot thoroughly. Rinse the cookpot at least twice by
filling with clean water and draining. Dry the cookpot thoroughly with a clean, dry towel.