Filter
Top Products
4-6
2. If an optional Power Shower is included,
install it now. NOTE: Verify that the
Power Shower O-ring and gasket are
present and in good condition and that
the clean-out screws are installed at each
corner.
Install the Power
Shower in the frypot
to be filtered.
Snap the optional Power Shower into position.
DANGER
If the fryer includes a Power Shower, DO NOT operate the filter without the Power
Shower in place. Hot oil will spray out of the fryer and cause injury.
3. After the cooking oil has drained from
the frypot, pull the filter handle forward
(outward) to start the pump and begin
the filtering process. There may be a
slight delay before the pump activates.
Pull filter handle forward
to activate pump.
4. The filter pump draws the cooking oil through the filter medium and circulates it back up to and
through the frypot during a 5-minute process called polishing. Polishing cleans the oil by
trapping solid particles in the filter medium.
5. After the oil is filtered (about 5 minutes), close the drain valve and allow the fryer to refill. Let
the filter pump run 10 to 12 seconds after the oil begins to bubble (or sputter from the Power
Shower openings, if installed). Turn the filter off, remove the Power Shower if installed, and let
it drain.