Filter
Top Products
1-10
Remove these four screws.
Remove screws along the top edge of
control panel and dismount the panel.
Remove these
screws (on both
sides) and remove
backsplash and
topcap.
Remove these screws to release
the pots from the standoff brackets.
Remove the top
connecting strip.
8. If removing the cookpot, disconnect the enrichment tubes and gas supply tubes from the burner
assemblies. Disconnect the ignition cables and flame sensor wires from the ignitor assemblies
on each burner.
9. Remove the blower.
10. Lift the cookpot or rinse tank straight up and out of the cabinet.
11. Invert the cookpot or rinse tank on a suitable work surface and remove the salvageable
components (e.g., probe block assembly, drain plumbing, etc.). Install the recovered components
on the replacement cookpot or rinse tank, using thread sealer on all connections.
12. Reverse Steps 1 through 9 to complete the procedure.