Frymaster DF400 H255-D260 Fryer User Manual


 
Frymaster
®
Application Series Gas Fryers
Model #_______________
CSI Section 11400
8700 Line Avenue
Shreveport, LA 71106-6800
USA
Tel: 318-865-1711
Tel: 1-800-221-4583
Fax: 318-868-5987
E-mail: info@frymaster.com
www.frymaster.com
Bulletin No. 818-0491 9/07
Litho in U.S.A. ©Frymaster, LLC
MODEL NO. OVERALL SIZE MM NET
WEIGHT
DRAIN
HEIGHT
SHIPPING INFORMATION
HEIGHT WIDTH LENGTH WEIGHT CLASS CU. FT. DIMENSIONS
DF400
H255-D260
45”
(1143)
71.25”
(1810)
36.5”
(927)
942 lbs.
(427 kg)
13”
(330)
1,000 lbs.
(373 kg)
77.5 109.5 H
55”
(1397)
W
80”
(2032)
L
43”
(1092)
DIMENSIONS
POWER REQUIREMENTS
HOW TO SPECIFY
DF400 H255-D260 Free-standing gas fryers with computer controls, under fryer
built-in oil filtration, stainless steel frypots, doors and cabinet.
NOTES
Supply Voltage 120V 60 Hz -- Control Voltage 24V 60
Hz.
120 VAC 5 ft. (1.5 m) grounded cord set provided.
Recommended minimum store supply pressure to be
6” W.C. for NAT Gas, and 11” W.C. for L.P. Check plumb-
ing codes for proper supply line sizing to attain burner
manifold pressure of 3.0” W.C. natural or 8.25” W.C. L.P.
Incoming supply line should be 1-1/2”. Should flexible
gas line be used, it must be AGA approved, commercial
type and sized per the gas line size in above drawing.
CLEARANCE INFORMATION
A minimum of 24” (610 mm) should be provided at the
front of the unit for servicing and proper operation,
and 6” (152 mm) between the sides and rear of the fryer
to any combustible material.
31.25
[794]
71.25
[1810]
INCHES
MM
36.50
[927]
45.75
[1162]
CONTROL
PANEL
FRONT VIEW
TOP VIEW
SIDE VIEW
1" GAS CONNECTION
80,000 BTU (PER EACH H55)
CORDSET CORDSET
1" GAS CONNECTION
150,000 BTU (PER EACH D60)
36.50
[927]
CORDSETS
DOWN SPOUT
GAS CONNECTIONS
CORDSET
11.25
[286]
MODEL
NO.
NATURAL OR LP GAS
INPUT RATING
ELECTRICAL GAS
CONNECTION
H55
80,000 BTU/hr. input
(20,151 kCal) (23.4 kW)
Non-basket lift
120V (1.0 AMP)
220V (0.5 AMP)
Basket Lift
120V (7.0 AMP)
220V (3.5 AMP)
1” N.P.T.
regulator not
required
H55-2
D60 150,000 BTU/hr. input
(37,783 kCal/hr.) (44 kW)
120V/60~1ø (3.5 AMP)
230V/50~1ø (2 AMP)
1” N.P.T.
regulator not
required
85UFF N/A 120V/60 Hz/1 ph
(6.2 AMP)
N/A
We reserve the right to change specifications appearing in this bulletin without incurring any obligation for equipment previously or subsequently sold.
MODEL MAX OIL
CAPACITY
LITERS
SIZE CM APPROXIMATE
WEIGHT
WIDTH DEPTH HEIGHT
85UFF 85 lbs. (42) 16.12” (41) 29.63”
(75.26)
10.25”
(26)
210 lbs. (95)
Model Shown is DF400 H255-D260
Other combinations are available.