Gaggia 12700 Coffeemaker User Manual


 
ENGLISH
 14 
3 Wipe body of machine with a damp cloth as
required.
4 Remove drip tray and plate (5-12) and wash
in warm soapy water. Do not use abrasive
substances.
5 Clean the seal (15) inside of the brewing
head (14) and keep it clean.
6 The shower disc (17) should be unscrewed
and cleaned periodically depending on
frequency of use.
7 After long periods of non-use, drain stale
water from machine by turning hot water/
coffee switch to 1. However, do this only
after you have filled tank with fresh water.
Never operate pump unless there is water
in tank.
8 NOTE: It is very normal for an espresso
machine to emit steam and drip occasionally
as the water pressure changes during use.
Be certain to empty drip tray (12) as
required,
Descaling:
In hard water areas, minerals found in the water
will accumulate and affect operation of the unit.
Approximately every two months (this can vary
depending on use and water condition), clean
the machine with Gaggia descaler (in which
case follow the instructions on the packet).
Remove shower disc (17) and clean.
Pour solution into tank and turn on pump for
15 seconds. Allow solution to flow through
brewing head and steam nozzle for several
seconds. Wait 20 minutes, then repeat. process
until solution has been run through.
Rinse machine thoroughly by running plain cold
water through machine. Replace shower disc
(17).
NOTE: Product failure due to scale
accumulation is not covered by warranty. No
other servicing should be attempted by the user.
Use Gaggia cleaner for best results.
Problem: Check to ensure against the following:
Coffee does not flow. Water is in tank.
Filter basket clo
gg
ed because coffee is too fine or com
p
ressed
too firml
y
.
Shower disc re
q
uires cleanin
g
.
Coffee flows too
q
uickl
y
. Coffee is
g
round too coarsel
y
.
Coffee is not
p
ressed down with tam
p
er.
Pum
p
makes loud noise. No water in tank.
Pum
p
not
p
rimed.
Coffee is
g
round too coarsel
y
.
Water leakin
g
excessivel
y
from filter holder.
Filter holder not
p
ro
p
erl
y
inserted in brew head.
Gasket in brewin
g
head dirt
y
or worn.
Coffee
g
rinds not cleaned off the rim of filter holder.
Es
p
resso has little cream
y
froth.
Coffee is
g
round too coarsel
y
.
Coffee is not
p
ressed down with tam
p
er.
Coffee is too old or dried out.
Es
p
resso is too cold. Machine is not warmed u
p
(6 min).
Coffee is
g
round too coarsel
y
.
Not enou
g
h milk froth. Steam nozzle and/or air intake hole clo
gg
ed.
Milk is too hot.
In the event of faulty function