GE 04-09 JR Double Oven User Manual


 
29
Consumer Support
Installation
Instructions
Troubleshooting Tips
Operating InstructionsSafety Instructions
The oven door must be closed and all controls set correctly for the cycle to work properly.
Before a Clean Cycle
For the first self-clean cycle, we recommend
venting your kitchen with an open window
o
r using a ventilation fan or hood.
Remove the racks, any broiler pan,
broiler grid, probe, all cookware and
any aluminum foil from the oven.
The oven racks can be self-cleaned,
but they will darken, lose their luster
and become hard to slide.
Soil on the front frame of the range and
outside the gasket on the door will need
to be cleaned by hand. Clean these areas
with hot water, soap-filled scouring pads or
cleansers such as Soft Scrub
®
. Rinse well
with clean water and dry.
Do not clean the gasket. The fiberglass
material of the oven door gasket cannot
w
ithstand abrasion. It is essential for the
gasket to remain intact. If you notice it
becoming worn or frayed, replace it.
Wipe up any heavy spillovers on the oven
bottom.
Make sure the oven light bulb cover is
in place and the oven light is off.
IMPORTANT: The health of some birds is
extremely sensitive to the fumes given off
during the self-cleaning cycle of any range.
Move birds to another well-ventilated room.
NOTE: Use caution when opening the upper
oven after the self-clean cycle has ended.
The oven may still be hot.
Using the self-cleaning upper oven. G
EAppliances.com
Wipe up heavy soil on the oven bottom.
How to Set the Upper Oven for Cleaning
Turn all surface burners off.
NOTE: The surface burners will not
function during self-clean cycle.
Touch the SELF CLEAN pad.
Using the number pads, enter the
desired clean time, if a time other than
4 hours is needed.
Clean cycle time is normally 4 hours. You can
change the clean time to any time between
3 hours and 5 hours, depending on how dirty
your oven is.
Touch the START pad.
The door and control will lock automatically.
The display will show the clean time
remaining. It will not be possible to open
the oven door until the temperature drops
below the lock temperature and the LOCKED
DOOR light goes off.
The oven shuts off automatically when
the clean cycle is complete.
When the LOCKED DOOR light is off,
the door will unlock automatically.
The words LOCK DOOR will flash and
the oven control will signal if you set
the clean cycle and forget to close the
oven door.
To stop a clean cycle, touch the
CLEAR/OFF pad. When the LOCKED DOOR
light goes off indicating the oven has
cooled below the locking temperature,
you may open the door.
Do not use the lower oven drawer during
a self-clean cycle.
The words ERR and TURN SURFACE
BURNERS OFF will flash and the oven
control will signal if you set the clean cycle
and forget to turn the surface burners off.