Filter
Top Products
PROBLEM
OVEN
WEL
NOT
COME ON
CONTROL PANEL
LIGHTED, YET OVEN
WKL
NOT START
‘TRObE”
APPEARS
ON DISPLAY
FLOOR OF THE OVEN
IS WARM, EVEN
W~N
THE OVEN
HAS NOT BEEN USED
POSSIBLE CAUSE
●
A fuse
in your home may be blown or the circuit breaker tripped. Replace fuse or
reset circuit breaker.
●
Unplug your microwave oven, then plug it back in.
●
Make sure 3-prong plug on oven is fully inserted into
wdl
receptacle.
●
Door
not
securely closed.
●
START pad must be touched
tier
entering cooking selection.
●
Another selection entered
aheady
in oven and
CLEWO=
pad
not
touched to
cancel
it.
●
Make sure you have entered cooking time after touching TIME COOK I & II pad.
●
CLENO~
pad was touched accidentally. Reset cooking program and touch
START pad.
●
Make sure you have entered a temperature after touching
TEMP
COOK pad.
●
Make sure You have entered a code number after touching
A~O
ROAST pad.
●
Probe
has been forgotten or
not
seated properly in oven
wdl
when
using
Temp
Cook or Auto Roast function.
●
The
cooktop
lamp is located
directiy
below the oven floor. When the lamp
is on, the heat it produces makes the oven floor get warm. This is normal.
All these things are normal with your microwave oven:
●
Steam or vapor escaping from around the door.
●
Dull thumping sound while oven is operating.
●
Light reflection around door or outer case.
●
Some TV-Radio interference might be noticed
●
Dimming oven
light
and change in blower sound
while
using
your microwave oven. It’s similar to
may occur while operating at power levels other
the interference caused by other small appliances
than high.
and does not indicate a problem with your oven.
If you need more
help...call,
toll free: GE Answer Center
@
/ 800.626.2000/ consumer information service
33