Filter
Top Products
Questions?
Use this
problem
solver
PROBLEM POSSIBLE CAUSE WHAT TO DO
Cloudiness on Combination of soft •This is called etching and is permanent.
glassware water and too much To prevent this from happening, use
detergent less detergent if you have soft water. Wash
glassware in the shortest cycle that will get
them clean.
Water temperature •Lower the water heater temperature.
entering the dishwasher
exceeds 150°F.
Black or gray Aluminum utensils have •Remove marks with a mild, abrasive
marks on dishes rubbed against dishes cleaner.
Yellow or brown film Tea or coffee stains •Remove the stain by hand, using a
on inside surfaces solution of 1/2 cup bleach and 3 cups
warm water.
WARNING
Before cleaning interior wait at least 20
minutes after a cycle for the heating
element to cool down. Failure to do so
can result in burns.
An overall yellow or •A special filter in the water supply line is
brown film can be caused the only way to correct this problem.
by iron deposits in water Contact a water softener company.
White film on inside Hard water minerals •To clean the interior, apply dishwasher
surfaces detergent to a damp sponge. Wear
rubber gloves. Do not use any type of
cleanser other than dishwasher detergent
because it may cause foaming or sudsing.
Dishes do not dry Low inlet water •Make sure inlet water temperature is
temperature correct.
•Select SPEED DRY Option.
Rinse agent dispenser •Check the rinse agent dispenser.
is empty
Control panel Door latch may not be •Call for service.
responded to inputs properly seated
but dishwasher never
filled with water
Dishwasher won’t run Fuse is blown, or the •Replace fuse or reset circuit breaker.
circuit breaker tripped Remove any other appliances from
the circuit.
•Try resetting the START/RESET pad.
Steam This is normal •Steam comes through the vent by the
door latch during drying and when water
is being pumped out.
Sanitized light does The door was opened and •Do not interrupt the cycle anytime
not illuminate at the the cycle was interrupted during or after main wash.
end of the cycle during or after the main
wash portion
The incoming water •Raise the water heater temperature to
temperature was too low 120°F.
19