Filter
Top Products
The electrode of the
spark igniter is
exposed when
the burner head is
removed. When one
burner is turned to
LITE
,
all the burners spark. Do not attempt to
disassemble or clean around any burner while
another burner is on. An electric shock may
result, which could cause you to knock over
hot cookware.
11
Sealed
burner
assemblies
Burner Cap
Burner Grate
Burner
Bowl
Burner Head
Turn all controls OFF before removing the
burner parts.
The burner grates, caps and burner heads
can be lifted off, making them easy to clean.
CAUTION: DO NOT OPERATE THE
BURNER WITHOUT ALL BURNER
PARTS IN PLACE.
For proper ignition, make sure the small hole in
the section that fits over the electrode is kept open.
A sewing needle or wire twist-tie works well to
unclog it.
The slits in the burner heads of your cooktop must
be kept clean at all times for an even, unhampered
flame.
You should clean the surface burners routinely,
especially after bad spillovers, which could clog
these openings.
To remove burned-on food, soak the burner heads
in a solution of mild liquid detergent and hot water
for 20-30 minutes. For more stubborn stains, use a
toothbrush.
Before putting the burner head back, shake out
excess water and then dry it thoroughly by setting it
in a warm oven for 30 minutes.
Replace the burner heads and caps. Make sure that
the heads and caps are replaced in the correct
location. There are 3 medium, one large and one
small head and cap.
NOTE: Before removing the burner heads
and caps, remember their size and location.
Replace them in the same location after
cleaning.
Use a sewing needle or twist-tie to
unclog the small hole in the burner
head. After cleaning, make sure the
slot in the burner head is positioned
over the electrode.
Electrode
Burner
heads
Medium Head
Medium Head
Small Head
Large Head
Front of Cooktop
Medium Head
Burner caps
Lift off when cool. Wash burner caps in hot, soapy
water and rinse with clean water. You may scour
with a plastic scouring pad to remove burned-on
food particles.
Dry them in a warm oven or with a cloth—don’t
reassemble them wet. Replace the burner caps.
Make sure that caps are replaced on the correct size
burner. There are 3 medium, one large and one
small head and cap.
Medium
Cap
Medium
Cap
Small
Cap
Large
Cap
Front of Cooktop
Medium
Cap