Filter
Top Products
5
1. Cabinet with overhang:
Fold the template along the dashed
line. Line up the edge of the
template to the edge of the cabinet
on the underside, then tape in
place.
Cabinet without overhang:
Fold template along the outside
edge of the bold line. Line up the
edge of template to the edge of the
cabinet on the underside, then tape
in place.
2. Mark the center of the four holes
through the template using a sharp
point (nail or awl).
3. Remove template and drill four
3/16" holes where marked.
CAUTION: Always use safety glasses
when drilling to avoid eye injury.
MOUNTING TEMPLATE
✁
(cut here)
✁
(cut here)
2.559 inches
Mark the CENTER of the holes here.
Front edge of cabinet (with overhang)
Align edge of paper with front edge of cabinet (without overhang).
Align edge of paper with side of cabinet or wall.
Align edge of paper with side of cabinet or wall.
Mounting Directions
4