Filter
Top Products
OPERATION
Tip: Operate the blender for only as long as needed to reach the right consistency.
Preferably operate for a few seconds at a time. Press the power ON/OFF button (1)
once the right consistency is reached.
Blending with countdown timer
The blender can be set with a time between 0:10 seconds and 3:00 minutes.
Press the power ON/OFF button (1) to switch on the blender.
Press start/stop button (3) to start operation. The LCD display (2) stops blinking
blend and 12. The blender starts with default speed 12.
Press up (6) while the blender is running to set the speed to the lowest setting 1.
Press down (8) to decrease the speed stepwise, as often as down (8) is
pressed.
Press timer button (11) to set the time for which the blender should be activated.
The LCD display (2) blinks timer.
The LCD display blinks timer and the default time of 1:00 minute. The blend and
speed 12 indicator stop blinking.
Press up (6) or down (8) button to adjust the time up or down in 10 seconds
increments or decrements.
Notes
The time entry stops after 5 seconds. If button is not pressed, the blender
goes back to speed setting mode. Press timer button (11) again, to enter
time entry mode.
The blender is not required to run in order to set the timer. It can be set
in stop mode.
The timer mode is only active after pressing timer button (11). After the
countdown cycle is completed, the timer indicator and time will turn
off.
Press and hold the up (6) or down (8) button to set time or speed
successively.
•
•
•
•
Press start/stop button (3) to start operation. The LCD display (2) shows the set time
as countdown.
Press up (6) or down (8) during countdown cycle to adjust the speed in
operation.
Press timer button (11) during countdown cycle and adjust the time with up (6)
or down (8) while in operation.
•
•
•
•
•
•
•
•
•
•
7
169202-EN-10.indd 7 6/1/09 1:14:28 PM