GE 681131692090 Coffeemaker User Manual


 
Client: PIL (Wal*Mart)
Project: 169209
Language: EN
Date: 13.07.2009
Version: 17
Page: 14 (of 18 pages)
CLEANING
Automatic clean function
The coffee maker is equipped with an automatic clean function. After 60 brewing cycles,
the clean indicator/button (21) lights up. This indicates that the coffee maker should
be cleaned using the automatic clean function and the charcoal filter (16) should be
replaced.
NOTE: The coffee maker can continue to be used, when clean indicator/button (21)
is on.
To begin the cleaning cycle, remove the charcoal filter (16) from the water tank (9). Fill the
tank with a vinegar and water mixture (½ vinegar and ½ water) or a descaling product.
Press and hold
clean button (21) for 2 seconds to start program. The coffee
maker beeps once before cleaning starts. The clean button (21) flashes while the
program is running.
Press and hold the clean button (21) for 3 seconds to stop program once it has
started.
Press button (29) anytime during clean cycle to stop program and allow the unit
to start to brew.
After completion of cleaning program or if power is lost during clean cycle, the
counter is reset, and the
clean button light (21) will go out.
Cleaning process:
Continuous cycles of 7 seconds brewing and 21 seconds off until tank is empty.
After cleaning process is complete the
clean indicator/button (21) goes off.
Fill water tank
(9) with clean water and run one brewing cycle to rinse the coffee
maker.
Change the charcoal filter (16) (ill.
k
). Reinsert the charcoal filter into the coffee
maker (ill.
l
).
NOTE: You can use the cleaning function before reaching 60 cycles by following the
steps above (especially if the water hardness in your area is above normal).
NOTE: Replacement water charcoal filters and carafes are available at WAL-MART stores.
14
CM-169209-17 (EN).indd 14 7/13/2009 5:09:18 PM