Filter
Top Products
Cycle Chart
Model Cycle Water Usage (gal.) Cycle Time (min.)
GSD3200J Series Hot Start Option
1
3.4 26
Pots & Pans 10.9 61
Normal Wash* 6.8 61
Short Wash* 6.2 48
Rinse Only* 4.5 13
Drying/Plate Warmer 0.0 30
EDW1500J Series Hot Start Option
1
1.7 33
GSD4000J Series Pots & Pans 10.9 71
GSD4100J Series Heavy Wash 9.3 71
GSD4200J Series Normal Wash* 6.8 71
SSD3900J Series China/Crystal 9.3 71
Short Wash* 6.2 58
Rinse Only*/Rinse & Hold* 3.0 13
Drying/Plate Warmer 0.0 30
* Normal Wash should be selected to run this cycle.
1
Hot Start Option adds water amount and cycle time shown when selected.
Note: Not all models have every cycle listed.
Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions
Energy Options
HI TEMP Provides extra heat for best performance. It is used best with heavily soiled dishes.
WASH (ON)
HI TEMP Turns HI TEMP WASH off.
WASH OFF (on some models)
HEATED DRY Turns the heating element on for fast drying. This option will extend the time of your wash cycle.
(ON) Available on all wash cycles except RINSE ONLY. Adds approx. 32 minutes to the cycle.
HEATED DRY Turns HEATED DRY off. Dishes air dry naturally and energy is saved.
OFF (on some models)
Cycles
POTS & PANS/ For heavily soiled dishes or cookware with dried-on or baked-on soils.
Everyday dishes may be included.
HEAVY WASH This cycle will not remove burned-on foods.
NORMAL WASH
For loads of everyday dishes, glasses and cookware with medium soils. NOTE: Many dishes have lighter soil than normal.
Choosing
a cycle other than NORMAL WASH will save energy and water.
SHORT WASH For quickly washing loads of everyday dishes with medium soils
that have not dried on, such as loads consisting
mostly of glasses.
RINSE ONLY For rinsing partial loads that will be washed later. Do not use detergent.
PLATE WARMER For warming clean dishes and serving plates. This cycle will take approximately 30 minutes.
HOT START Preheats wash water to the correct temperature.
Start
Slowly turn t
he Dial to the START or ON position, or the selected cycle. Don’t turn it past the START, ON
or cycle position, or you could accidentally miss a rinse.
There is a time delay between start-up and water fill so you will not hear any wash action right away.
■ Latch the door to begin the cycle.
Control Settings
GEAppliances.com
5