Filter
Top Products
Listed below are the control error codes the customer could see or hear
and possible fixes:
No light with
continuous beeping
sound
Key pad not plugged in or model
typing resistor on keypad circuit
board not detected
Check and repair or replace the following as required:
1. Keypad plugged in
2. Keypad
3. Control
Normal light with
beeping sound
Normal light flashes and control
beeps when the detergent trip motor
cannot find its home position
Check and repair or replace the following as required:
1. Connections to detergent trip motor
2. Operation of trip motor sensing switch
3. Operation of trip motor
4. Cam and detergent trip mechanism for free operation
5. Control
Note: No lights flash when cycle is cancelled and the dishwasher is resetting.
Normal light with
beeping sound
Start/Reset
Non-sensor models
Flashing Light Explanation Possible Cause
Normal operation
Check and repair or replace the following as required:
1. Jumper resistor – correct and properly plugged in
2. Control
Normal light flashes when the
detergent trip motor cannot find its
home position
Cycle cancelled, dishwasher resetting
Check and repair or replace the following as required:
1. Connections to detergent trip motor
2. Operation of motor sensing switch
3. Operation of trip motor
4. Cam and detergent trip mechanism for free operation
5. Control
Clean light with
beeping sound
Model typing plug not detected
Flashing Light Explanation Possible Cause
Sensing light and
continuous beep
Check and repair or replace the following as required:
1. Turbidity sensor connections
2. Turbidity sensor
3. Control
Check and repair or replace the following as required:
1. Control
Control is reading the tub
temperature sensor as open or short
circuit (thermistor is in the turbidity
sensor)
Control is receiving an unexpected
signal from the turbidity sensor
Check and repair or replace the following as required:
1. Turbidity sensor connections
2. Turbidity sensor
3. Control
Lock light EEPROM error
Sensor Models
Flashing Light Explanation Possible Cause
Listed below are control error codes visible only during the F1 test and only on sensor models.
Heated dry light