Filter
Top Products
GEAppliances.com
Select Options (Continued)
Steam (Prewash) For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be selected PRIOR to
(on some models)
starting the sycle. The Steam option adds approximately 30 minutes to the cycle time. This option is
available with all cycles except Rinse only.
Wash Selecting either the Upper or Lower Wash Zones will target dishwashing of just one rack. This will
Zones shorten the cycle time and conserve energy. This option can be used when there is only half a
(on some models)
load of dishes.
Delay Delays the start of a wash cycle up to 8 to 12 hours depending on model. Touch Delay Hours, touch to select
Hours the number of hours, then touch Start one time to begin countdown. Dishwasher will start once allotted time
(on some models) has expired.
Control You can lock the controls to prevent selections from being made. You can also lock the controls
Lock after you have started a cycle to prevent uninterrupted cycle changes.
For example, children cannot
accidentally start the dishwasher by touching pads with this option selected.
To LOCK the dishwasher control, depending on the model, touch and hold the Heated Dry pad for 3 seconds or touch
and hold the Steam and Wash Temp pads at the same time for 3 seconds. The light will turn on to indicate the control is
locked.
To UNLOCK the dishwasher control, depending on the model, touch and hold the Heated Dry pad for 3 second or
touch and and hold the Steam and Wash Temp pads at the same time for 3 seconds. The light will turn off to indicate
the control is unlocked.
Start Dishwasher
Start Door can be open to start the cycle and select desired options. Touch the Start pad one time to begin
the cycle. Close the door to start the cycle or begin the Delay Hours countdown. The wash cycle will
begin shortly after closing door. If the door is open, the illuminated lights will turn off if a pad is not
touched within two minutes. To activate the display, close and open the door or touch any pad.
Interrupt To interrupt or pause a dish cycle, open the door. Opening the door will cause the wash cycle to
or Pause pause. The dishwasher will beep every minute to remind you to close the door. To restart or resume
the cycle, touch Start, and close the door.
Cancel To cancel a wash cycle, touch and hold the Start pad for 3 seconds and close door. The dishwasher
will drain, emit a beep sound, and the wash cycle light will turn OFF.
Cycle Completion
Sanitized
Displayed at the end of the cycle when Wash Temp Sani (Sanitize) has been selected and the dishwasher
has met the requirements for sanitization. See Wash Temp Sani above, for complete cycle description.
Opening the door or touching any key while the door is closed will turn off the light.
Clean Displayed when a wash cycle is complete. The light stays ON as a reminder that the dishes are clean.
Opening the door or touching any key while the door is closed will turn the light off.
5
6
5
7