Filter
Top Products
Installation Instructions
STEP 3 CONNECT THE UNICOUPLE TO THE
FAUCET
, Run garbage disposer,
if you have one, to
clean out the disposer
and thus allow water
to drain from the sink
through the disposer
and down the drain.
, Run hot water faucet to
purge cold water from
iollar
the hot water line.The hot water must be between !20°F and
!BO°F for best wash performance.
Roll the dishwasher to a position just in front of the sink.
Pullthe unicouple and its hoses completelg out from storage
compartment at rear of the dishwasher.
Attach the unicouple to the faucet adapter following the three
steps below:
- Depressthe locking collar at the top of the unicouple
- Placethe unicouple completelg over the faucet adapter
- Releasethe locking collar. The unicouple should now be
locked onto the faucet adapter.
Turn on the hot water faucet and check for leaks. If leak is
detected, disconnect the unicouple, and refer to Step 4.
Note: The unicouple's small hose carries water from the
faucet to the dishwasheE The large hose carries water from
the dishwasher to the sink. Orient the faucet with unicouple
attached so water from the unicouple will run into the sink drain.
STEP 4 FAUCET ADAPTER LEAK
Skip this step if no unicouple leak was observed
If a unicouple leak was observed in Step 3,take whatever
actions are necessarg to repair the leak. This mag be as simple
as tightening the faucet adapter. Or, it mag require the services
of a plumber if water is leaking from the interface between the
moveable faucet arm and the fixed part of the faucet fastened
to the sink.
STEP 5 PRETEST CHECK LIST
Review this list after connecting gour dishwasher to avoid
charges for a service call that is not covered bUgour warrant U.
[] Open door and remove all foam and paper packaging.
[] Locate the Owner's Manual.
[] Readthe Owner's Manual to familiarize yourself with the
operation of the dishwasher.
[] Remove the protective film, if present, from the control
panel.
[] Add 2 quarts of water to the bottom of the dishwasher to
lubricate the pump seal.
STEP 6 DISHWASHER WET TEST
Plug power cord into outlet.
Close and latch dishwasher doon
Start dishwasher:
Timer Dial Models
- PressNormal pad
- Turn dialjust enough to start dishwasher. Dial should point
to "Hot Start". Do not turn the dial too faE If gou turn it too
far gou will "bU pass" the fill.
Electronic Models
- Press"Rinse Onlg"
- Pressthe start pad one time.
Check to be sure that water enters the dishwasher. This could
take up to 4 minutes on dial models.
If water does not enter the dishwasher
- Check to be sure that the water is turned on
- Lightlg tap the flood float cover to dislodge a stuck flood
float.
- On dial models, make sure gou did not turn the dial past the
first fill. If this happened, unlatch the door and rotate the
dial to "Off". Re-latch door and turn the dial one click at a
time until the dishwasher starts.
- On electronic models, make sure the start pad was pressed
one time onlU.
Float
Cover