Filter
Top Products
7
Step-by-step installation instructions.
Faucet Installation for Model GN1S15CBL (rev. 2) only
Be sure there is room underneath the sink to make
the needed connections. Select one of the following
places to install the faucet:
—IN an existing sink spray attachment or soap
dispenser hole.
—IN a hole to be drilled in the sink top.
—IN a hole to be drilled in the countertop, next
to the sink.
NOTE: Looking at second illustration at right, be sure
the faucet base will fit flat against the surface at the
selected location so the gasket will seal.
If drilling is needed, make a 3⁄4″ to 1″ dia. hole.
Be sure to use the proper procedure for drilling
porcelain or stainless steel. Special drill bits may
be needed.
Place small gasket, base and large gasket (in that
order) onto the faucet stem. Next, place lock
washer and hex nut onto faucet stud.
Insert washer into tubing adapter. Securely
tighten to faucet stud.
Feed the length of 3⁄8″ OD tube from the
bottom up through the mounting hole.
Connect to the tubing adapter as shown in
second illustration, tightening the compression
nut securely.
Remove the short shipping tube and insert
the spout into the faucet body. Rotate spout
into place.
Lower the faucet assembly into place on the
underside of the mounting hole. Place
the
mounting bracket above the lock washer.
While holding the mounting bracket in place,
securely tighten the hex nut.
6
5
4
3
2
1
Sink
Base
Lock washer
Faucet
Lever
Spout
Faucet
stud
Small gasket
Large gasket
Compression nut
Tubing adapter
Mounting bracket
Hex nut
Tubing
insert
3/8″ tubing, (run
to Filter II outlet)
Compression nut
ASSEMBLED
Tubing adapter
Tubing
insert