Filter
Top Products
Operation of electronic models (model GSD4000 Only)
Using the Dishwasher Door
door must be closed and locked into place to select a LOAD SELECTIONor an OPTION.
Ifthe door isopenedduring a cgcleand left open,thedishwasherwill beeponceevery30 secondsuntil the
door is cosed and arched into p ace.
Start
Close and latch the doon Touch the START/RESET pad to begin the cycle. Water fill begins and
approximately 60 seconds later the wash action begins.
NOTE:The dishwasher remembers your last cgcle so you don't have to reprogram each time. When
the dishwasher is loaded and the door latch is in the locked position, the control panel lights will be ON
and displag the last settings you selected.
If you don't want to change ang of the settings, simply touch the START/RESETpad to begin
the cycle.
Also, if a power failure occurs, NORMAL and HEATEDDRYwill automatically be programmed.
Hake any new selections and touch the START/RESETpad to begin the cycle.
Clean
This light is illuminated when a wash cgcle is complete. The light will stag ON until the door is opened.
Flashing Displag Lights
Lights What It Means What To Do
This is normal. Allow the dishwasher to drain and reset before you start a new
The START/RESET pad wash cycle.
has been pressed.
Control Error
CLEAN
Pressthe START/RESETpad to turn off the beeper If the CLEAN
light continues to flash,call for service.
PLUS A
BEEPING
SOUND
a
Asj
PLUS A
BEEPING
SOUND
Control Error
Pressthe START/RESETpod to turn off the beeper and the
dishwasherwill attempt to reset. Restartthe wash cgcle.
If this error continues,turn off the power to the dishwasher at
the circuit breakerfor 30 seconds.Try the dishwasheragain.
If the error is still present, call for service.
8