Filter
Top Products
Cycle Chart
Model Cycle Water Usage (gal.) Cycle Time (min.)
GSD2200, Hot Start Option
1
3.4 26
GSD2201 Pots & Pans 9.2 71
Normal Wash* 6.3 71
Short Wash* 3.8 58
Rinse Only* 2.5 13
Drying/Plate Warmer 0.0 27
GSD2600 Hot Start Option
1
3.4 26
Heavy Wash 9.2 71
Normal Wash* 6.3 71
Light Wash* 5.0 62
Rinse Only* 2.5 13
Drying/Plate Warmer 0.0 27
GSD2700 Hot Start Option
1
3.4 26
Heavy Wash 9.2 71
Normal Wash* 6.3 71
Short Wash* 3.8 58
Rinse Only* 2.5 13
Drying/Plate Warmer 0.0 27
* Normal Wash should be selected to run this cycle.
1
Hot Start Option adds water amount and cycle time shown when selected.
Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions
Energy Options
HI TEMP Provides extra heat for best performance. It is used best with heavily-soiled dishes.
WASH ON
HI TEMP Turns
HI TEMP WASH
off.
WASH OFF
HEATED DRY ON Turns the heating element on for fast drying. This option will extend the time of your wash cycle.
Available on all wash cycles except
RINSE ONLY
. Adds approx. 32 minutes to the cycle.
HEATED DRY OFF Turns
HEATED DRY
off. Dishes air dry naturally and energy is saved.
Cycles
POTS & PANS/ For heavily soiled dishes or cookware with dried-on or baked-on soils.
Everyday dishes may be included.
HEAVY WASH This cycle will not remove burned-on foods.
NORMAL WASH
For loads of everyday dishes, glasses and cookware with medium soils.
NOTE:
Many dishes have lighter soil than normal.
Choosing
a cycle other than
NORMAL WASH
will save energy and water.
SHORT WASH For quickly washing loads of everyday dishes with medium soils
that have not dried on, such as loads consisting
mostly of glasses.
LIGHT WASH For dishes with light soils.
RINSE ONLY For rinsing partial loads that will be washed later.
Do not use detergent.
PLATE WARMER For warming clean dishes and serving plates. This cycle will take approximately 30 minutes.
HOT START Preheats wash water to the correct temperature.
Start
Slowly turn t
he Dial to the
START
or
ON
position, or the selected cycle. Don’t turn it past the
START, ON
or cycle position, or you could accidentally miss a rinse.
There is a time delay between start-up and water fill so you will not hear any wash action right away.
■ Latch the door to begin the cycle.
Control Settings
GEAppliances.com
5