Filter
Top Products
Options
The light above the selected pad will be ON to indicate which OPTION has been selected.
POWER For use with heavily soiled and/or dried-on, baked-on soils. This option
PRESOAK
MUST
be selected
PRIOR
to starting the cycle.
This option adds 16
minutes to the cycle time.
HI TEMP RINSE Turns on the heater in all prerinse and final rinse cycles to help prevent
spotting on dishware. This option may be turned
ON
or
OFF
during the
wash cycle.
HEATED DRY Shuts off the drying heat options. Dishes air dry naturally and energy is
OFF
saved. You can prop the door open after the light goes
ON
next to the
word
CLEAN
which appears in the
STATUS
display for faster drying.
HEATED DRY Turns the heater on for fast drying. This cycle will extend the time
ON
to your wash cycle by 30 minutes.
NOTE:
Cannot be selected with
RINSE & HOLD
cycle.
LOCK
When the
LOCK
pad is touched twice within 3 seconds, all pads become
inoperative.
You can lock the controls to prevent any selections from being made.
Or you can lock the controls after you have
started a cycle or selected DELAY
START so the cycle or DELAY START is not interrupted.
Children cannot accidentally start dishwasher by touching pads
with this option selected.
To unlock the dishwasher after it has been locked, touch the
LOCK
pad twice
within 3 seconds. The light above the
LOCK
pad will be off.
DELAY START You can delay the start of a wash cycle for up to 8 hours. Press and hold
the
DELAY START
pad to choose the number of hours you want to delay
the start of the cycle. The machine will count down and start automatically
at the correct time.
NOTE:
If you forget to lock the door a reminder signal
will beep until you do so.
RESET To change a cycle after washing starts, touch the
START/RESET
pad to
cancel the cycle. After water is pumped out and motor stops, you can
reprogram and restart the dishwasher.
Customer ServiceTroubleshooting TipsOperating InstructionsSafety Information
3
Start
Close the door until it locks into place and touch the
START/RESET
pad to
begin the cycle. There is a time delay between start-up and water fill so you
will not hear any wash action right away.
The cycle is complete when the light is
ON
next to the word
CLEAN
in the
STATUS
display.
4
NOTE:
The dishwasher remembers your last cycle so you don’t have to
reprogram each time. When the dishwasher is loaded and door latch is
in the locked position, the control panel lights will be
ON
and display the
last settings you selected.
If you don’t want to change any of the settings, simply touch the
START/RESET
pad to begin the cycle.
Also, if a power failure occurs,
NORMAL
and
HEATED DRY
will automatically
be programmed. Make any new selections and touch the
START/RESET
pad to begin the cycle.
9