Filter
Top Products
For long vacations or absences, set both power switches
(on the back of the dispenser) to the O (off) position.
1. Unplug the water dispenser.
2. Remove the water bottle.
3. Drain the water tanks (see Draining the Dispenser).
4. Dry the separator thoroughly on both the top and bottom
(see Cleaning the Separator).
5. Leave the door of the chiller compartment open
(on some models).
After returning from vacation, make sure to sanitize the water tanks
before using the dispenser (see Cleaning and Sanitizing the Water Tank).
Preparing for Vacation
Chilling Rate: approx. 0.5 gallons (2 liters) per hour
Heating Rate: approx. 0.8 gallons (3 liters) per hour
Capacity: 3 or 5 gallon bottle
Power Consumption: Heating: 480 watts max.
Cooling: 125 watts max.
Specifications
Defrosting
(GXCF20E/GXCF20FBB Chiller Model)
Defrost whenever frost on the wall of the chiller compartment becomes
excessive. Never use a sharp or metallic instrument to remove frost
as it may damage the liner. We recommend using a plastic scraper.
Do not use any electrical device in defrosting your chiller compartment.
To defrost:
■Remove items from the compartment.
■Turn the Cold (Blue) Power switch to off and unplug
the dispenser.
■Put several towels in the bottom of the compartment
to collect water.
Defrosting usually takes a few hours. To defrost faster,
keep the door open.
After defrosting:
■Remove the wet towels and wipe up any remaining water.
■Wipe the compartment with a dry cloth.
■Plug in the unit and turn on the Cold (Blue) power switch.
Return items to the unit.
Troubleshooting Tips.
Problem Possible Causes What To Do
Water has poor taste Separator needs cleaning. •See Cleaning the Separator.
or odor
Unit needs to be sanitized. •See Cleaning and Sanitizing the Water Tanks.
Water not hot enough Dispenser is unplugged. •Push the plug completely into the outlet.
or cold enough
The fuse is blown/circuit •Replace house fuse or reset the house circuit breaker.
breaker is tripped. •If too many items are plugged into a single circuit, move
some items to a different circuit.
All the water in the water tank •Wait 30 minutes for water to heat or cool.
has been used.
Temperature limiter tripped. •Set the hot and cold power switches (on the back of the
dispenser) to the O (off) position. Wait five minutes; then
set the switches to the I (on) position. Wait 30 minutes for
water to heat or cool.
Water dispenser does Empty water bottle. •Replace with a new bottle of water.
not work – No water flow
Mineral deposits clogging tanks. •See Care and Cleaning.
Cold water button Chiller door has been left open. •Close chiller door.
does not dispense
Ice buildup blocking water flow. •Turn off cold power switch overnight and flip back on in
the morning.
Water dispenser leaks Crack or pin hole in bottle. •Replace with a new bottle of water.
from the outside
Compressor does not start Normal Operation—Compressor •Wait for up to 3 minutes for the compressor to start.
when cold power switch/ start is delayed by up to 3 minutes
blue light is on to prolong the compressor life.
Bottle feels warm Water system overfilled. •Dispense cold water until air is released into the bottle.
Water is boiling in the hot tank
and bubbling up into the bottle.
Care and cleaning of the dispenser.
8