Filter
Top Products
15
Installation Instructions
ROUTE AND ATTACH THE
PLASTIC WATER LINE
• Route the plastic water line along the back of the
refrigerator to the water tube inlet.
• Use the three adhesive backed fasteners (5) to
secure the plastic water line to the case back.
5
4
CONNECT THE WATER LINE
• Make sure there is enough plastic water line to
extend from the water valve to well into the
water tube inlet (14). Cut off any excess tubing.
• Squeeze the ends of the hose clamp (3) or (6)
from the kit with pliers and slide the clamp over
the water tube inlet. (Use the black clamp (3) with
the black water tube inlet, use the other clamp (6)
with the other water tube inlet.)
• While still squeezing the clamp, insert the plastic
water line into the inlet as far as it will go
(approximately 1″ [25 mm]).
• Then slide the clamp downward to capture the
plastic water line in place.
• Make sure the fill tube is aimed down.
3
Water tube
inlet
WATER VALVE INSTALLED
Refer to the Water Line Installation Instructions
for connection to the home water supply. After
water line installation is completed, set the
icemaker power switch to I (on).
The icemaking cycle will not begin until the icemaker
and freezer compartment reach operating temperature,
then icemaking will begin automatically.
6
Adhesive-backed fasteners
for plastic water line
6
or