Filter
Top Products
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions
22
Using the self-cleaning oven.
Before a Clean Cycle
We recommend venting your kitchen
with an open window or using a
ventilation fan or hood during the
first self-clean cycle.
Remove the racks, broiler pan, broiler
grid, all cookware and any aluminum foil
from the oven.
NOTES:
■ If your oven is equipped with shiny,
silver-colored oven racks, remove them
before you begin the self-clean cycle.
■ If your oven is equipped with gray
porcelain-coated oven racks, they may
be left in the oven during the self-clean
cycle.
Soil on the front frame of the range and
outside the gasket on the door will need
to be cleaned by hand. Clean these areas
with hot water, soap-filled steel wool pads
or cleansers such as Soft Scrub
®
. Rinse
well with clean water and dry.
Do not clean the gasket. The fiberglass
material of the oven door gasket cannot
withstand abrasion. It is essential for the
gasket to remain intact. If you notice it
becoming worn or frayed, replace it.
Wipe up any heavy spillovers on the oven
bottom.
Make sure the oven light bulb cover is in
place and the oven light is off.
IMPORTANT:
The health of some birds
is extremely sensitive to the fumes given
off during the self-cleaning cycle of any
range. Move birds to another well-
ventilated room.
Wipe up heavy soil on the oven
bottom.
How to Set the Oven for Cleaning
Follow the directions in the
Before a
Clean Cycle
section.
WARNING:
The surface
units are automatically disabled during
the self-clean cycle. Make sure that all
surface unit controls are turned off at all
times during the self-clean cycle. Any
surface unit that is set to an on position,
while the self-clean cycle is operating, will
automatically come on after the self-clean
cycle is finished, and could result in an
on, unattended surface unit. Wait until
the self-clean cycle is finished to set and
use the surface units.
Latch the door.
NOTE:
Never force the latch. If the oven is
too hot, you will not be able to slide the
latch. Allow the oven to cool.
Touch the
CLEAN
pad.
Touch the
+
or
–
pads until the
desired Clean Time is displayed.
The Clean Time is normally 4 hours. You can
change the Clean Time to any time between 3
and 5 hours, depending on the amount of soil in
your oven.
Touch the
START/ON
pad.
The self-clean cycle will automatically
begin after
CLEAN
is displayed and the
time countdown appears in the display.
While the oven is self-cleaning, you can
touch the
CLOCK
pad to display the time
of day. To return to the clean countdown,
touch the
CLEAN
pad.
The oven shuts off automatically when
the clean cycle is complete, and 0:00 will
flash in the display.
Slide the latch handle to the left as
far as it will go and open the door.
It will not be possible to unlatch the oven
door until the temperature drops below
the lock temperature and the
LOCKED
door light goes off.
When the
LOCKED
door light is off,
unlatch the door.
Never force the latch handle. Forcing the handle will damage the door lock mechanism.
(on some models)