Filter
Top Products
8
Consumer Support
Troubleshooting Tips
Care and Cleaning Operating Instructions Safety Instructions
Using the surface units.
Be sure you turn the control knob to
OFF when you finish cooking.
Dual Surface Unit Control Knob (on some models)
The right front surface unit has 2 cooking sizes
(15.2 cm [6
″
] and 22.9 cm [9
″
] or 22.9 cm [9
″
] and
30.5 cm [12
″
] depending on model) to select from
so you can match the size of the unit to the size of
the cookware you are using.
On some models, the left front surface unit
also has 2 cooking sizes (12.7 cm [5
″
] and 20.3 cm
[8
″
] or 15.2 cm [6
″
] and 22.9 cm [9
″
] depending
on model).
To use the small surface unit, turn the
control knob
counterclockwise
to the
SMALL BURNER
settings.
To use the large surface unit, turn the
control knob
clockwise
to the
LARGE
BURNER
settings.
How to Set
Push the knob in and turn in either
direction to the setting you want.
At both
OFF
and
MAX
the control
clicks
into position. You may hear slight
clicking
sounds during cooking, indicating the
control is keeping the power level you set.
A
HOT
surface indicator light, on
the cooktop, will glow when any radiant
element is turned on. It will remain
on until the surface is cooled to
approximately 65.5°C (150°F).
Hot surface indicator light will:
■
come on when the unit is hot to the touch.
■
stay on even after the unit is turned off.
■
glow until the unit is cooled to approximately
65.5°C (150°F).
WARNING:
The surface
units are automatically disabled during
the self-clean cycle. Make sure that all
surface unit controls are turned off at all
times during the self-clean cycle. Any
surface unit that is set to an on position,
while the self-clean cycle is operating, will
automatically come on after the self-clean
cycle is finished, and could result in an
on, unattended surface unit. Wait until
the self-clean cycle is finished to set and
use the surface units.
30.5 cm (12")
or
22.9 cm (9")
22.9 cm (9")
15.2 cm (6")
or
20.3 cm (8")
12.7 cm (5")
22.9 cm (9")
or
15.2 cm (6")
or
Using the Bridge Burner (on some models)
To use the bridge burner, turn the
left front control knob
clockwise
to the
BRIDGE BURNER
settings.
For full bridge surface unit operation,
also turn on the left rear surface unit.
To use only the front surface unit, turn
the control knob
counterclockwise
to the
FRONT BURNER
settings.