Filter
Top Products
Operating the Self-Cleaning Oven
How to Set Oven for Cleaning
1. Follow the directions in the Before a Clean Cycle
section.
2. After closing the door, press the
AUTO SELF CLEAN pad.
3. Press the INCREASE or DECREASE pad until the
desired Clean Time is displayed.
Clean Time is normally 3 hours. You can change the
Clean Time to any time between 2 and 4 hours,
depending on the amount of soil in your oven.
The self-clean cycle will automatically begin after
“CLEAN” is displayed and the time for the clean cycle
is set. The words “ON” and “LOCK” will appear in the
display when the door automatically locks. It will not be
possible to open the oven door until the temperature
drops below the lock temperature and the LOCK light
goes off.
4. When the LOCK light is off, open the door.
NOTE:
• You can find out when the clean cycle will be finished
by pressing the STOP TIME pad.
• The word “door” will be displayed, the word “LOCK”
will flash and oven control will signal if you set the
clean cycle and forget to close the oven door.
• A fan may automatically turn on and off to cool
internal parts. This is normal, and the fan may
continue to run after the oven is turned off.
CLEAN
AUTO SELF
Quick Reminder:
1. Press the AUTO SELF CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
How to Delay Start of Cleaning
Delay Start is setting the oven timer to start the clean
cycle automatically at a later time than the present time
of day.
NOTE: Before beginning, make sure the oven clock
shows the correct time of day.
1. Follow the directions in the Before a Clean Cycle
section.
2. After closing the door, press the
AUTO SELF CLEAN pad.
3. Press the INCREASE or DECREASE pad
to enter the Clean Time.
4. Press the STOP TIME pad. “STOP
TIME” and the earliest Stop Time you can
set will appear in the display.
The earliest Stop Time will be the Clean Time selected
plus the time of day. For example: If the Clean Time is
three hours and the time of day is 6:00, the Stop Time
that appears in the display will be 9:00.
5. Press the INCREASE pad to change the Stop Time
to a later time of day if desired. For example: If you
set Stop Time at 11:00, oven will start clean cycle at
8:00 and end at 11:00. The door latches
automatically.
The self-clean cycle will automatically begin after
“CLEAN” is displayed and the time for clean cycle
is set. The words “ON” and “LOCK” will appear in
the display when the door automatically locks. It will
not be possible to open the oven door until the
temperature drops below the lock temperature and
the LOCK light goes off.
6. When the LOCK light is off, open the door.
NOTE:
• During a delayed self-clean operation you can find
out when the oven is set to turn on by pressing and
holding the AUTO SELF CLEAN pad for 3 seconds.
• A fan may automatically turn on and off to cool
internal parts. This is normal, and the fan may
continue to run after the oven is turned off.
(continued next page)
STOP
TIME
CLEAN
AUTO SELF
Quick Reminder:
1. Press the AUTO SELF CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
3. Press the STOP TIME pad.
4. Press the INCREASE or DECREASE pad until
the desired Stop Time appears in the display.
23