Filter
Top Products
49
ge.com
Problem Possible Causes What To Do
Display goes blank
A fuse in your home may be • Replace the fuse or reset the circuit breaker.
(on some models)
blown or the circuit
breaker tripped.
The clock is turned off so that it • See the
Using the clock and timer
section.
does not show in the display.
Display flashes
Power failure. • Reset the clock.
(on some models)
Unable to get the
Oven control pads were • The
Bake
and
Broil Hi/Lo
pads must be touched at
display to show “SF”
not touched properly. the same time and held for 3 seconds.
(on some models)
Power outage,
Power outage or surge. • Reset the clock. If the oven was in use, you must reset
clock flashes
it by touching the
Clear/Off
pad, setting the clock and
(on some models)
resetting any cooking function.
“Burning” or “oily” odor
This is normal in a new oven • To speed the process, set a self-clean cycle for a
emitting from the vent
and will disappear in time. minimum of 3 hours. See the
Using the self-cleaning
oven
section.
Strong odor
An odor from the insulation • This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise
A cooling fan may automatically • This is normal. The cooling fan will turn off and on.
turn on and off to cool
internal parts.
Drawer does not slide
The drawer is out of alignment. • Fully extend the drawer and push it all the way in.
smoothly or drags
See the
Care and cleaning of the range
section.
Drawer is over-loaded or load • Reduce weight. Redistribute drawer contents.
is unbalanced.
Operating
Instructions
Care and Cleaning
Installation
Instructions
Troubleshooting Tips
Safety Instructions
Consumer Support