GE JGP626 Cooktop User Manual


 
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips
Consumer Support
11
Cleaning the glass cooktop surface. (on some models) GEAppliances.com
Normal Daily Use Cleaning
ONLY use the recommended cleaning
cream included with your cooktop on
the glass surface. Other creams may
not be as effective.
To maintain and protect your glass
surface, follow these steps.
Before using the cooktop for the
first time, remove the burner
grates and vent grille, and clean
the glass surface with the cooktop
cleaning cream. This helps protect
the top and makes cleanup easier.
Daily use of the cooktop cleaning
cream will help keep the glass
surface looking new.
Shake the cleaning cream well.
Apply a few drops of the cream
directly to glass surface.
Use a paper towel or sponge to
clean the entire glass surface.
NOTE: It is very important that you DO NOT
heat the cooktop until it has been cleaned
thoroughly.
Burned-On Residue
WARNING: DAMAGE to your glass surface
may occur if you use scrub pads other than
the pad included with your cooktop.
Allow the glass surface to cool.
Remove the burner grates and
spread a few drops of cooktop
cleaner over the entire burned
residue area.
Using the included scrub pad, rub
the residue area, applying pressure
as needed.
If any soil remains, repeat the steps
listed above as needed.
For additional protection, after
all residue has been removed,
polish the entire glass surface with
cooktop cleaner and a paper towel.
The RAZOR SCRAPER is available
through our Parts Center. See
instructions under “To Order Parts”
section on next page.
NOTE: Do not use a dull or nicked
blade.
Clean your cooktop after each spill.
Heavy, Burned-On Residue
Allow the cooktop to cool.
Remove the burner grates and
spread a few drops of cooktop
cleaner over the entire burned
residue area.
Use a razor scraper at approximately
a 45° angle against the glass surface
and scrape the soil. It will be
necessary to apply pressure to the
razor scraper in order to remove
the residue.
Keep a small amount of cream on
the soil as you scrape.
After scraping with the razor
scraper, use the scrub sponge to
remove any remaining residue.
For additional protection, after all
residue has been removed, polish
the entire glass surface with
cooktop cleaner and a paper towel.
Included scrub pad
COOKTOP
CLEANER