Filter
Top Products
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.com
LP Conversion Gas Cooktop
Instructions
JGP985
Adjustable wrench
PART QUANTITY
Brass orifices 4
Stick-on conversion label 1
Small, thin-blade flat screwdriver with approximately 1/8″
blade width is needed to access the calibration screw.
49-80298
4226-0018-00
01-05 JR
Printed in Korea
1
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT – Save these instructions for
local inspector’s use.
•
IMPORTANT – Observe all governing codes
and ordinances.
• Note to Installer – Be sure to leave these instructions
with the Consumer.
• Note to Consumer – Keep these instructions
for future reference.
• This cooktop is factory set for natural gas operation.
Conversion to LP operation should be performed by a
qualified technician or installer. Keep these instructions
for future reference. When converting to LP, save the
original parts for possible future use.
• Product failure due to improper installation is not covered
under the GE Appliance Warranty.
FOR YOUR SAFETY
WARNING – If you are using LP (bottled) gas,
all adjustments described in the following steps must be
made before attempting burner adjustments or use of the
cooktop.
WARNING – This conversion kit shall be
installed by a qualified service agency in accordance with
the manufacturer’s instructions and all applicable codes
and requirements of the authority having jurisdiction.
If the information in these instructions is not followed
exactly, a fire, explosion or production of carbon
monoxide may result, causing property damage, personal
injury or loss of life. The qualified service agency is
responsible for the proper installation of this kit. The
installation is not proper and complete until the operation
of the converted appliance is checked as specified in the
manufacturer’s instructions supplied with the kit.
TOOLS YOU WILL NEED
PARTS INCLUDED