Filter
Top Products
31
Operating Instructions
Safety Instructions
Consumer Support
Troubleshooting Tips
Problem Possible Causes What To Do
Display goes blank A fuse in your home may be • Replace the fuse or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is in the • See the Special features of your oven control section.
black-out mode.
Display flashes Power failure. • Reset the clock.
Unable to get the Oven control pads were • The BAKE and BROIL HI/LO pads must be touched at
display to show “SF” not touched properly. the same time and held for 2 seconds.
Power outage, Power outage or surge. • Reset the clock. If the oven was in use, you must reset
clock flashes it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
“Burning” or “oily” This is normal in a new oven • To speed the process, set a self-clean cycle
odor emitting from and will disappear in time. for a minimum of 3 hours. See the Using the
the vent self-cleaning oven section.
Strong odor Improper air/gas ratio in oven. • Adjust the oven burner air shutter.
Insulation around the inside • This is normal in a new oven, and will disappear
of the oven. in time.
Fan noise A cooling fan may turn on • This is normal. The fan will run until the function
and off automatically. is over or the door is opened.
Cannot see flames on both Bright glow of igniter makes • See the Broiling section.
sides of broil burner flames difficult to see.
Burners have yellow or Combustion quality of • Use the illustrations below to determine if your
yellow-tipped flames burner flames needs to be burner flames are normal. If burner flames look
determined visually. like A, call for service. Normal burner flames should
look like B or C, depending on the type of gas you
use. With LP gas, some yellow tipping on outer cones
is normal.
A–Yellow flames B–Yellow tips C–Soft blue flames
Call for service on outer cones Normal for natural
Normal for LP gas gas
ge.com