Filter
Top Products
5
Safety Instructions Operating Instructions Care and Cleaning Installation Instructions Troubleshooting Tips Consumer Support
Using the warming drawer. www.GEAppliances.com
The warming drawer will keep hot, cooked foods at serving temperature. Always start with hot food. Do not
use to heat cold food other than proofing yeast dough, crisping crackers, chips or dry cereal.
Control Knob
The warming drawer controls are hidden
with the drawer shut. Open the drawer.
The controls are on the right side of the
front frame.
To use the warming drawer, press the
ON/OFF switch to the ON position.
Slide the moisture selector control to the
open or closed setting. (See the Moisture
Selector section.)
Turn the control knob to the desired
setting.
PROOF . . . . . . . . . . . . . . . . 75–95°F
LOW . . . . . . . . . . . . . . . . . 140–160°F
MED . . . . . . . . . . . . . . . . . 160–195°F
HIGH . . . . . . . . . . . . . . . . . 195–230°F
PROOF
HI
MED
LO
M
oist
Closed
Vent
Crisp
Open
Vent
ON Signal Light
The ON signal light is located below
the ON/OFF switch and glows when the
ON/OFF switch is in the ON position.
It stays on until the ON/OFF switch is
moved to the OFF position.
The ON signal light is visible through the
light viewer in the drawer front panel
when the drawer is closed. This is a
reminder that the heat is on.
Additional Pans
An accessory pan kit JXPN2 is available
from GE at extra cost.
Two pans with lids (4” deep)
■ One large pan (14 quarts)
■ One medium pan (6 quarts)
Moisture Selector
The moisture selector is located on the
inside front of the drawer.
To keep foods moist, slide the moisture
selector control away from the control
knob. This closes the vent and seals the
moisture inside the drawer. With the vent
closed hot foods stay moist and soft.
In this setting condensation may occur around
the inside edge of the drawer.
To keep foods crisp, slide the moisture
selector control to the right towards the
control knob. This opens the vents and
allows the moisture to escape.
With the vents open, it is normal for moisture to
collect on surfaces above the warming drawer.