Filter
Top Products
Rotisserie
Models
JRP14GJ,
JKF16GJ
Food is cooked by revolving on
a spit under the (upper) broil unit.
As food turns, it bastes itself to
produce a succulent brown and
tender roast. Meat tender enough
for roasting may be rotissed.
1. Assemble rotisserie. Insert
curved ends of frame into large
holes of broiler pan handles. Lock
frame in place by fitting straight
ends of support into holes in center
handles.
2. Secure food on spit. When
secured correctly, food will be
located in center area of spit
leaving 4 inches free at the pointed
end (this part goes into motor).
3. To secure food on spit: Push
2-pronged fork onto spit near
handle end. Tighten with screw.
Push spit through food (tie food
securely and compactly), distributing
weight evenly on each side of spit.
To check weight distribution on
spit, hold spit (and food) between
hands, palms up; spit should roll
smoothly from palms to fingertips
when palms are tipped forward.
Finish securing food on spit by
gliding second 2-pronged fork onto
spit with prongs toward food. Tighten
screws to a flat surface on spit.
4. Insert spit into motor: Grasp
handle on spit. Using point of spit,
move to one side the cover over
motor outlet in rear of oven; push
spit firmly into motor outlet as far
as it will go. Remove handle.
5. Check rotation of food. Tighten
or adjust forks if necessary. During
cooking, forks may need tightening
due to normal meat shrinkage.
6. As food cooks, leave door ajar in
“Broil” position; door stays open
by itself.
7. Baste food if desired. With pot
holders, pull out pan and shelf
together to shelf stop. Attach
handle to spit to revolve food by
hand while basting. To continue
cooking push shelf and broiler pan
into oven, insert spit into motor,
remove handle.
4. Place spit on frame so handle end
is in narrow support, and pointed
end is in wide U-shaped support.
Rotissing the Food
1.
Put oven shelf in lowest position
in oven. With food on spit, place
spit on oven shelf.
2. Set OVEN TEMP knob as
suggested on Rotisserie Time and
Temperature Guide at right. Settings
are 300-400”F. to get foods juicy
and done without overbrowning.
3. Switch OVEN SET knob to
ROTISSERIE. This starts broil unit
and rotisserie motor operating. Spit
can be inserted and removed more
easily when motor is operating.
N~E:
Make certain when touching
spit that no part of body or pot
holder touches coils of broil unit.
Rotisserie Notes
● Do not use electric meat
—
thermometer, on models so
equipped, while operating the
rotisserie. A regular, non-electric
meat thermometer may be used
while rotissing providing it doesn’t
touch the oven, frame or pan while
meat revolves. (Or, if desired, cook
to estimated doneness then pull
meat from oven to insert meat
thermometer. Wait about 2 minutes
for temperature to register. If meat
is not done, remove thermometer
and continue cooking if necessary. )
. If rotissing turkey, let stand in
warm oven 10 to 20 minutes after
cooking to assure juicy meat and
complete doneness.
. At end of cooking pull out pan
and shelf together, using pot
holders. Turn OVEN SET to OFF.
Remove food from spit. Cool pan
outside oven; soak forks and screws
for easiest clean up.
—
18