GE JN322 Ventilation Hood User Manual


 
1. PREPARATION OF WALL CABINET
AND WALL
FLUSH OR RECESSED BOITOM CABINET
NOTE: For easier installation make all hood and
vent cutouts in the cabinet and wall before cabinet is
permanently fastened in place. It is recommended that
the power supply be brought into the hood from the wall
below the cabinet as shown in Fig. 1. However, an
optional location is shown in Fig. 2, where the power
supply enters the top of the hood by passing through
the wall cabinet.
A. WALL CABINET WITH RECESSED BOTTOM:
Add the 2 required filler strips as shown in Fig. 3.
B. WALL CABINET WITH FLUSH BOTTOM: In
some cases it may be necessary to provide clearance
for the connection box cover mounting screw which
extends slightly through the top of the hood. Clearance
can be provided, if necessary, by carefully positioning
the hood against the bottom of the cabinet and marking
the screw position; clearance may then be provided
by drilling a 1/4” hole in the cabinet bottom.
-=
‘lGURE1
1X’
dia. clearance hole in wall for
recommended power supply location
Centerline matches up with
centerof
qnge or
cooktop.
FIGURE 2
66” from bottom
for optional power
of cabinet to floor
supply location
RECESSED BOITOM
These filler strips
support the entire
weight of the hood.
Make sure they are
mounted firmly and
are flush with the
cabinet bottom.
FIGURE 3
5