Filter
Top Products
9
ge.com
To clean the surface units, turn the control to the highest setting for a minute. The coils will burn off any soil.
Safety Instructions Operating Instructions Care and Cleaning Installation Instructions Troubleshooting Tips Consumer Support
Surface Units and Drip Pans
CAUTION
■ Be sure all the controls are turned to
OFF and the surface units are cool
before attempting to remove them.
■ Do not immerse the surface units in
liquids of any kind.
■ Do not clean the surface units in a
dishwasher.
■ Do not bend the surface unit plug
terminals.
■ Do not attempt to clean, adjust or in
any way repair the plug-in receptacle.
To remove a surface unit:
To remove the drip pans for cleaning,
the surface units must be removed first.
Lift the surface unit about 1 inch above
the drip pan and pull it out.
Do not lift the surface unit more than 1
inch. If you do, it may not lie flat on the
drip pan when you plug it back in.
Repeated lifting of the surface unit more
than 1 inch above the drip pan can
permanently damage the receptacle.
To replace a surface unit:
■ Replace the drip pan into the recess in
the cooktop. Make sure opening in the
pan lines up with the receptacle.
■ Insert the terminals of the surface unit
through the opening in the drip pan
and into the receptacle.
■ Guide the surface unit into place so it
rests evenly.
Drip Pans
Remove the surface units. Then lift out
the drip pans.
For best results, clean the drip pans by
hand. Place them in a covered container
(or a plastic bag) with 1/4 cup ammonia
to loosen the soil. Then scrub with a soap
filled scouring pad if necessary. Rinse
with clean water and polish with a clean
soft cloth.
The drip pans may also be cleaned in the
dishwasher.
Clean the area under the drip pans often.
Built-up soil, especially grease, may catch
on fire.
Do not cover drip pans with foil. Using
foil so close to the receptacle could cause
shock, fire or damage to the cooktop.
Lift the surface unit about 1 inch
above the drip pan and pull it out.