Filter
Top Products
Bridge Surface Unit (on some models)
You can create an oblong heated area by using
the left rear unit in addition to the front unit
bridge combination.
Make sure the pan rests flat on the glass
cooktop.
When the select knob points to ,
the control knob controls both the left
front surface unit and the bridge area.
Choose pans that match the
circle/bridge area as closely as possible.
When the select knob points to ,
the control knob controls the left front
surface unit only.
Dual Surface Unit (on some models)
The right front surface unit has 2 cooking sizes to
select from so you can match the size of the unit
to the size of the cookware you are using.
To use the large (9-inch) surface unit,
turn the SELECTOR knob clockwise to .
Push in and turn the control knob to the
desired setting. The unit will heat the
entire area contained by the larger circle.
To use the small (6-inch) surface
unit, turn the SELECTOR knob
counterclockwise to . Push in and
turn the control knob to the desired
setting. The unit will only heat the area
inside the smaller circle.
Small 6"
surface unit
setting
Large 9"
surface unit
setting
Temperature Limiter
Every radiant surface unit has a
temperature limiter.
The temperature limiter protects the
glass cooktop from getting too hot.
The temperature limiter may cycle the
units off for a time if:
■ The cooktop is on while cooking.
■ The pan boils dry.
■ The pan bottom is not flat.
■ The pan is off-center.
■ There is no pan on the unit.
6
Safety Instructions
Operating Instructions
Care and CleaningTroubleshooting TipsConsumer Support
Using the surface units.