Filter
Top Products
30
Safety Instructions
Operating Instructions
Care and CleaningTroubleshooting TipsCustomer Service
Before you call for service…
Troubleshooting Tips
Problem Possible Causes What To Do
“F— and a number or You have a function error code. • Press the CLEAR/OFF pad. Allow the oven to cool for
letter” flash in the display one hour. Put the oven back into operation.
If the function code repeats. • Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
Display flashes Power failure. • Reset the clock.
Unable to get the Oven control pads were • The BAKE and BROIL HI/LO pads must be pressed
display to show “SF” not pressed properly. at the same time and held for 3 seconds.
Power outage, Power outage or surge. • Reset the clock. If the oven was in use, you must reset
clock flashes it by pressing the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
“Burning” or “oily” This is normal in a new oven • To speed the process, set a self-clean cycle for a
odor emitting from and will disappear in time. minimum of 3 hours. See the Using the self-
the vent cleaning oven section.
Strong odor An odor from the insulation • This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
Improper air/gas ratio in • Call for service.
the oven.
Fan noise A cooling fan may • This is normal. The cooling fan will turn off and on.
automatically turn on and
off to cool internal parts.