GE JSP31 Range User Manual


 
Delay Start is setting the oven timer to start the clean
cycle automatically at a later time than the present
time of day.
NOTE: Before beginning, make sure the oven clock
shows the correct time of day.
1. Follow the directions in the Before a Clean
Cycle section.
2. After closing the door, press the AUTO
SELF CLEAN pad.
3. Press the INCREASE or DECREASE
pad to enter Clean Time.
4. Press the STOP TIME pad. “STOP
TIME” and the earliest Stop Time you
can set will appear in the display.
The earliest Stop Time will be the Clean Time
selected plus the time of day. For example: If the
Clean Time is three hours and the time of day is 6:00,
the Stop Time that appears in the display will be 9:00.
5. Press the INCREASE pad to change the Stop Time
to a later time of day if desired. For example: If
you set Stop Time at 11:00, oven will start clean
cycle at 8:00 and end at 11:00. The door latches
automatically.
When the time of day reaches the automatic start
time, CLEAN, ON and LOCK appear in the display.
6. When the LOCK light is off, open the door.
NOTE:
• During a delayed self-clean operation you
can find out when the oven is set to turn
on by pressing and holding the AUTO
SELF CLEAN pad for 3 seconds.
• A fan may automatically turn on and off to cool
internal parts. This is normal and the fan may
continue to run after the oven is turned off.
CLEAN
AUTO SELF
STOP
TIME
CLEAN
AUTO SELF
Easy Reference:
1. Press the AUTO SELF CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
3. Press the STOP TIME pad.
4. Press the INCREASE or DECREASE pad until
the desired Stop Time appears in the display.
26
How to Set Delay Start of Cleaning
OPERATING THE SELF-CLEANING OVEN
(continued)
After Self-Cleaning
You may notice some white ash in the oven. Just wipe
it up with a damp cloth after the oven cools.
If white spots remain, remove them with a soap-
filled steel wool pad. Be sure to rinse thoroughly
with a vinegar and water mixture. These deposits
are usually a salt residue that cannot be removed
by the clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
If the shelves have become hard to slide, wipe the
shelf supports with cooking oil.
NOTE: No functions can be programmed before the
door automatically unlocks.