GE JSP42 Range User Manual


 
Care and cleaning of the range.
www.GEAppliances.com
Be sure all controls are off and all surfaces are cool before cleaning any part of the range.
How to Remove Packaging Tape
To assure no damage is done to the finish
of the product, the safest way to remove
adhesive left from packaging tape and
labels on new appliances is an application
of a household liquid dishwashing
detergent, mineral oil or cooking oil.
Apply with a soft cloth and allow to soak.
Wipe dry and then apply an appliance
polish to thoroughly clean and protect
the surface.
NOTE: The adhesive must be removed from all
parts. It cannot be removed if it is baked on.
If your range is removed for cleaning, servicing or any reason, be sure the anti-tip
device is reengaged properly when the range is replaced. Failure to take this
precaution could result in tipping of the range and cause injury.
Control Knobs
The control knobs may be removed for easier
cleaning.
Before removing the knobs for
cleaning, please note that the knobs
are in the OFF position. When replacing
the knobs, check the OFF position to
insure proper placement.
Wash the knobs in soap and water or
a vinegar and hot water solution but
do not soak.
Oven Vent
The oven vent is located above the left side of
the door.
This area could become hot during
oven use.
It is normal for steam to come out of
the vent.
The vent is important for proper air circulation.
Never block this vent.
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support
Stainless Steel Surfaces (on some models)
Do not use a steel-wool pad; it will
scratch the surface.
Shake bottle well.
Place a small amount of CERAMA
BRYTE
®
Stainless Steel Appliance
Cleaner on a damp cloth or damp
paper towel.
Clean a small area (approximately
8x 8), rubbing with the grain of
the stainless steel if applicable.
Dry and buff with a clean, dry paper
towel or soft cloth.
Repeat as necessary.
NOTE: If a mineral oil-based stainless steel
appliance cleaner has been used before
to clean the appliance, wash the surface
with dishwashing liquid and water prior
to using the CERAMA BRYTE
®
Stainless
Steel Appliance Cleaner. After washing
the surface with dishwashing liquid
and water, use a generous amount
of CERAMA BRYTE
®
Stainless Steel
Appliance Cleaner to clean the appliance.
To Order
To order CERAMA BRYTE
®
Stainless
Steel Appliance Cleaner, please call our
toll-free number:
National Parts Center 800.626.2002
www.GEAppliances.com
CERAMA BRYTE
®
Stainless Steel Appliance
Cleaner . . . . . . . . . . . . . . . . . . . .# PM10X311
21