Filter
Top Products
24
Safety InstructionsOperating InstructionsCare and CleaningTroubleshooting TipsConsumer Support
Before You Call For Service…
Troubleshooting Tips
Problem Possible Causes What To Do
“F— and a number
You have a function • Press the
CLEAR/OFF
pad. Allow the oven to cool for
or letter” flash
error code. one hour. Put the oven back into operation.
in the display
If the function • Disconnect all power to the oven for at least 30
code repeats. seconds and then reconnect power. If the function
error code repeats, call for service.
Display goes blank
A fuse in your home may • Replace the fuse or reset the circuit breaker.
be blown or the circuit
breaker tripped.
The clock is in the • See the
Special features of your oven control
section.
black-out mode.
Display flashes
Power failure. • Reset the clock.
Unable to get the
Oven control pads were • The
BAKE
and
BROIL HI/LO
pads must be pressed
display to show “SF”
not pressed properly. at the same time and held for 3 seconds.
Power outage,
Power outage or surge. • Reset the clock. If the oven was in use, you must reset
clock flashes
it by pressing the
CLEAR/OFF
pad, setting the clock
and resetting any cooking function.
“Burning” or “oily”
This is normal in a • To speed the process, set a self-clean cycle for a
odor emitting from
new oven and will minimum of 3 hours. See the
Using the self-cleaning
the vent
disappear in time.
oven
section.
Strong odor
An odor from the insulation • This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
Fan noise
A cooling fan may • This is normal. The cooling fan will turn off and on.
automatically turn
on and off to cool
internal parts.