Filter
Top Products
5
Cabinet Width 30”
Recommended
Minimum
Cutout Location
from Floor 21 5/8”
Cutout Depth 23 1/2” Min.
Cutout Width 28 1/2” Min.
28 5/8” Max.
Cutout Height 42 3/16” Min.
42 1/4” Max.
If the cabinet does not have a solid bottom,
two braces or runners must be installed
level with the bottom of the cutout to
support the weight of the oven. The
runners and braces must support 255 lbs.
Installation Instructions
NOTE: If the cabinet does not
have a front frame and the
sides are less than 3/4” thick,
shim both sides equally to
establish the cutout width.
Cutout for Built-In Oven
with Microwave
A
NOTE: If marks, blemishes or the
cutout opening are visible above the
installed oven, it may be necessary to
add wood shims under the runners and
front trim until the marks or opening
are covered.
C
L
SUITABLE
BRACING
TO SUPPORT
RUNNERS
2" x 4" or
EQUIVALENT
RUNNERS
21 5/8"
OVER CENTERLINE
OF CABINET
2” x 4” or
equivalent
runners
level with
bottom
of cutout
Suitable
Bracing
to Support
Runners
21 5/8”
Over Centerline
of Cabinet
CUTOUT
WIDTH
28 1/2" MIN.
28 5/8" MAX.
20"
28"
JUNCTION BOX
LOCATION
TO BOTTOM OF
JUNCTION BOX
*CABINET
WIDTH
30"
ALLOW A MINIMUM
OF 21" FOR CLEARANCE
TO ADJACENT CORNERS,
DRAWERS, WALLS, ETC.
WHEN DOORS ARE OPENED.
ALLOW 11/16"
FOR OVERLAP
OF OVEN OVER
SIDE EDGES
OF CUTOUT.
ALLOW 1" FOR
OVERLAP
OF OVEN TOP
AND BOTTOM
OF CUTOUT.
CUTOUT
HEIGHT
42 3/16" MIN.
42 1/4" MAX.
RECOMMENDED
CUTOUT
LOCATION
21 5/8"
21"
THE OPENING
BETWEEN INSIDE
WALLS MUST
BE A LEAST
28 1/2" WIDE
Junction Box
Location
20”
Cabinet
Width
30”
Allow minimum
1” for overlap of
oven top and
1
1
⁄
4
” overlap of
bottom of cutout
Allow 11/16” for
overlap of oven
over side edges
of cutout
21”
Allow a minimum of 21”
for clearance to adjacent
corners, drawers, walls,
etc. when door is open
Recommended
minimum cutout location
from floor 21 5/8”
28”
to Bottom of
Junction Box
Cutout
Height
42 3/16” Min.
42 1/4” Max.
Cutout Width
28 1/2” Min.
28 5/8” Max.
Opening
between
inside walls
must be
at least
28 1/2” wide