Filter
Top Products
6
Installation Instructions
Cutout for Built-In Oven with
Microwave models only – Over
a Warming Drawer
For JKP90, JTP90, PT970 models only.
A
30″ (76.2 cm) Oven with
Microwave Oven (Models
JTP90 and PT970) Over a
Warming Drawer
Anti-Tip Block
Against Rear
Wall Per Warming
Drawer Requirement
2” (5.1 cm)
Min.
1” (2.5 cm) Min. Above Toekick
Per Warming
Drawer
Requirement
Anti-Tip Block
Against Rear
Wall Per
Warming Drawer
Requirement
2” (5.1 cm)
Min.
1” (2.5 cm) Min. Above Toekick
Per Warming
Drawer
Requirement
27″ (68.6 cm) Oven with
Microwave Oven (Model
JKP90) Over a Warming
Drawer
NOTE: Additional clearances between cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location
do not obstruct the required interior depth and
height.
• When installing a Warming Drawer below
a single or double oven, a separate 120V,
60 Hz, properly grounded receptacle must
be installed. Refer to installation instructions
packed with the Warming Drawer for
specific installation requirements.
NOTE: Install the
oven only with
specific models
listed on the label
located on top of
the oven.