Filter
Top Products
Use and Care of Recirculation Hood Model JN327
and Ventilating Hood Models JV327, JV337 & JV347
IMPORTANT SAFETY
INFORMATION
READ ALL INSTRUCTIONS
BEFORE USING.
WARNING—TO REDUCE THE RISK
OF FIRE, ELECTRIC SHOCK OR
INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
A. Use this unit only in the manner intended by
the manufacturer. If you have any questions,
contact the manufacturer.
B. Before servicing or cleaning unit, switch
power off at service panel and lock the service
disconnecting means to prevent power from
being switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag,
to the service panel.
CAUTION—For general ventilating use only.
Do not use to exhaust hazardous or explosive
materials and vapors.
When you get your new hood…
• Have it installed and properly grounded by
a qualified technician in accordance with the
installation instructions.
• Have the installer show you the location of
the hood circuit breaker or fuse and mark it
for easy reference.
• Take the time to read our suggestions for best use.
WARNING—TO REDUCE THE RISK
OF FIRE, ELECTRIC SHOCK OR
INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
A. Installation work and electrical wiring must be
done by qualified person(s) in accordance with
all applicable codes and standards, including
fire-rated construction.
B. Sufficient air is needed for proper combustion
and exhausting of gases through the flue
(chimney) of fuel burning equipment to prevent
back drafting. Follow the heating equipment
manufacturer’s guidelines and safety standards
such as those published by the National Fire
Protection Association (NFPA), and the
American Society for Heating, Refrigeration
and Air Conditioning Engineers (ASHRAE),
and the local code authorities.
C. When cutting or drilling into wall or ceiling,
do not damage electrical wiring and other
hidden utilities.
D. Ducted fans must always be vented to the
outdoors.
WARNING—To reduce the risk of fire,
use only metal ductwork.
When using your hood…
• Never leave surface units unattended at high
settings. Boilover causes smoking and greasy
spillovers that may ignite and spread if hood is
used. Use surface unit heat settings recommended
by the manufacturer and adequate-size utensils.
• Never use your cooking appliance for warming
or heating the room. The electrical wiring of
your range hood may not withstand the resulting
excessive heat.
• Keep the hood clean and clean grease filter
or replace charcoal filter as recommended to
maintain good venting and to avoid grease fires.
WARNING—TO REDUCE THE RISK
OF A RANGE TOP GREASE FIRE:
A. Never leave surface units unattended at high
settings. Boilovers cause smoking and greasy
spillovers that may ignite. Heat oils slowly on
low or medium settings.
B. Always turn hood ON when cooking at high
heat or when cooking flaming foods.
C. Clean ventilating fans frequently. Grease should
not be allowed to accumulate on fan or filter.
D. Use proper pan size. Always use cookware
appropriate for the size of the surface element.
(continued next page)
GE Quality Product