Filter
Top Products
11
REMOVE EXHAUST ADAPTOR
Remove the 7″ round exhaust adaptor from the top of
the hood. Set it aside along with its mounting screws.
7″ round
exhaust
adaptor
REMOVE FILTERS
Remove the shipping tape holding the metal grease
filters in place. Pull down on the filter tabs and lift the
filters out. Set them aside.
REMOVE BOTTOM COVER
On models so equipped, remove the bottom cover
from the hood. Set the cover and its mounting screws
aside.
Bottom cover
(held in place
with 2
screws)
REMOVE OTHER EXHAUST ADAPTOR
Remove the 3
1
⁄4″ x 10″ rectangular exhaust adaptor
from inside the hood. Set it aside along with its
mounting screws and parts bag. Depending on the
model, the exhaust adaptor will be located on the
left or right side.
3
1
⁄4″ x 10″
rectangular
exhaust adaptor
3
1
⁄4″ x 10″
rectangular
exhaust adaptor
REMOVE WIRING COVER
On models so equipped, remove the wiring cover from
inside the hood. Set the cover and its mounting screw
aside.
Wiring
cover
REMOVE WIRING KNOCKOUT
Remove either the top or the back wiring knockout as
needed and install an approved strain relief clamp.
Strain relief
clamp
2
3
4
5
6
7
Installation Instructions
Filters